Pfaff creative 1472 Owner's Manual - Page 36
Darning, elastic, stitch, Inserting, patches, fabrics, Automatic, darning, Changing, length
View all Pfaff creative 1472 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
. .:.: •' , :- - Darning with elastic stitch prog 13a Depending on the size of the damaged area, stitch over it with as many elastic stitch seams as are needed to cover it Each seam should just slightly overlap the erie before it (Fig 1). Inserting patches prog 13a --- f3 OA Stitch length 05 mm Needle position down The new piece of tabric is pinned on the face side and the fabric edge over-sewn with the selected stitch To make the patch mere durable you can sew a second seam at sewing foot width from the first Afterwards cut away the damaged material en the inside IFig 2) Darning torn fabrics prog (tJ 13al5 35 PA For mending tears. frayed edges and small holes. place a piece of material under the torn tabric which is larger than the damaged area. Stitch over the area at the width of the tear. The material underneath reinforces the damaged material and ensures reliable darning Trim any protruding material on the underside close to the edge lFig 31 72 I ,; 9 "'- --z--•:'---- -, 111 1 rvW - * 'lit [ifn' I, lii iii, iii huh U2 Automatic darning prog 94 -3 f 2A,5A R Sewing thread: embroidering and darning thread The darning program 94 is mainly intended for R darning damaged spots Stitch over the damaged spot at the required length, then press the "reverse' key. The length of the darning seam is now memorized in the computer. The Pfaff Crea tive then automatically stitches over the damaged area. The programmed darn size can then be repeated as often as required. If the worn area is wider than the darning program, the darning program must be repeated several times until the damaged spot has been covered completely. Depending on the fabric, the darn may turn out one-sided If so, this can he compensated by hal ance key 5 Example: • Fig. 1: Using balance key, select - 1 to + 3 or more, if required. Fig. 2: Using balance key, select-ito 3 or more, it required. If you wish to darn a larger area we recommend to use buttonhole foot 5A The darning program must be repeated several times until the damaged spot has been covered a Changing the darning length If you wish to change the programmed dar length, press the "pattern start key". The dan length is cleared and a new length can be grammed 7