Pfaff creative 1472 Owner's Manual - Page 46

//I R Er R B R R Buttonho'e with gimp thread Eyelet ouuonnoie witn gimp In the case of elastic. rnafei ala, it is pocarhie that thread the buttonholes estend 1 herefor a, tile hutton hole strip should he reinforced wit 1 it e I in op material ri order to retain the shape nf the button Srr,tabfr' ltrieads' head yarn Ho 8 or thick sewing thread hole, rise qrmp threart if possible Place the pimp • Move runrrer hqhtly to the rear thread over the hack ridge 'A' prrfl taut anrt jam it • lam the pimp thread iirtu the left of rirtpe A' into front ridqe B' to the left and right (Fig 1) (Fig 3) and pull to the front ijnrter the button (Pull runner fully to the front). hole runner The buttonhole ceriieoce is the same as without • Place fever the front ridge B and jam it to tIre rump thread After completroru the buttonhole pull on the left girnp threarl (Fig 2) until the loop is right end left lFrg 4) • Pull rt to the rear agair anrt jam it into the right R covered rip by the bar This is where the button will of rirtge 'A" iFig 5) be lorurtert later • Place the fabric rroderreaih the searing foot, On elastic materials pull the aimp threads throuqh • pull the buttonhole runner fully to the front to ttre reverse side with a needle and tie them off anrt lower the sewing foot On normal fabrics ttre pimp threads can be • Before you start sewino press slow sewing" lrimrnert immediately trehind tire last bartack key 16 (Fig 6) • Sew the first hirftonhote seam • When the machine starts sewrng slowly (at ttr After sewing, cut the buttonholes open (see page 94). beginning of the curve), take the gimp threart from the left of rrrtgo A", • pull rtown (he thread frorn rirtge •B by mriarrs of a neertle anrt trill it to the rca r ii r it ii a loot) appears in needle plate cutout C' of the (rut fonhole runner (Fig 71 • Sew the curve aurd when the machine has again reached its nnnmal speed - • pull the thread taut cod finish sewiniq the hut tonbole To prevent the pimp threarts from chownq at the enrt of the hartack, pull them taut cod cut them off Round buttonholes with gimp threads ire sewrr in exactly the same way Note: the thicker the pimp thread you use, ltre wider the buttonhole seams must he selected to corres pond with the threrid 6 92