Pioneer BDP-V6000 Owner's Manual - Page 16

02  Specially shaped discs Specially shaped discs (heart-shaped, hexagonal, etc.) cannot be used on this player. Never use such discs, as they will damage the player. 3 Mount the rack mount brackets. Mount the rack mount brackets to the screw holes in the sides of the player using the screws removed from the player in step 2 (two screws on each side). Screw holes  Condensation on discs If the disc is moved suddenly from a cold place into a warm room (in winter, for example), water droplets (condensation) may form on the disc surface. Discs will not play properly if there is condensation on them. Carefully wipe off the water droplets from the disc surface before using the disc.  Extended use of recording discs Playing a specific section of a recording disc (BD-R/RE, DVD-R/RW, etc.) continuously for extended periods of time may reduce performance of the recorded surface and make the disc unplayable. To avoid this, take measures so that no single specific section is played for extended periods of time, and replace the disc periodically. Installation Procedure Screws removed from player Rack mount bracket • The rack mount brackets are different for the left (L) and right (R) sides. Check the L and R marks on the rack mount brackets and be sure to mount them on the correct side. • When mounting, first tighten the two screws removed from the player to the extent that the rack mount bracket moves when a gentle force is applied, check that the rack mount bracket is properly attached, then tighten the screws securely. 1 Disconnect all cords connected to the set (including the power cord). Before starting, check that there is no disc in the set. 2 Turn the set upside-down, and remove the screws on the sides of the set. Remove the 2 screws from each side. Caution • When mounting, be sure to place the set on a stable surface, such as on a flat table, and raise the side of the set on which you are mounting the rack mount bracket by at least 10 mm. Mounting the rack mount bracket without raising the set at least 10 mm could damage the set. • When mounting the rack mount bracket, be sure to use the screws removed from the player. Using other screws could damage the set or result in the set 16 falling. En