Pioneer BDP-V6000 Owner's Manual - Page 68
TV Aspect Ratio
UPC - 012562957227
View all Pioneer BDP-V6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
09 Problem Check Remedy No picture is displayed or the Are you using an extremely Using an extremely long cable may result in noise. Use a relatively short picture is not displayed long cable? cable. properly. Picture freezes and the front panel and remote control buttons stop working. • Press STOP to stop playback, then restart playback. • If the playback cannot be stopped, press STANDBY/ON on the player's front panel to turn off the power, then turn the power back on. • If the power cannot be turned off, press and hold STANDBY/ON on the player's front panel for over 5 seconds. The power will turn off. Motion is unnatural or picture is not clear. Change the Pure Cinema setting (page 39). No picture is displayed or picture is not output in high definition when playing BDs. With some discs, it may not be possible to output the video signals from the VIDEO output terminal or the COMPONENT VIDEO output terminals. In this case, connect using an HDMI cable (page 18). • Picture is disturbed during playback. • Picture is dark. • This player supports Macrovision analog copy protection technology. With some TVs (such as with built-in video deck), the picture will not be displayed properly when the copy protected DVD title is played. This is not a malfunction. • If the player and TV are connected via a DVD recorder/video deck, etc., the picture will not be displayed properly due to analog copy protection. Connect the player and TV directly. • Picture is stretched. • Picture is cropped. • Aspect ratio cannot be switched. Is the TV's aspect ratio properly set? Read the TV's operating instructions and set the TV's aspect ratio properly. Is TV Aspect Ratio properly Set TV Aspect Ratio properly (page 42). set? Is 4:3 Video Out properly set? Set 4:3 Video Out properly (page 42). Is DVD 16:9 Video Out properly set? Set DVD 16:9 Video Out properly (page 42). When video signals with a resolution of 1080/60i, 1080/60p, 720/60p, 1080/24p, 1080/50i, 1080/50p or 720/50p are being output from the HDMI OUT terminal or the COMPONENT VIDEO output terminals, they may be output with an aspect ratio of 16:9 even if TV Aspect Ratio is set to 4:3 (Standard) (page 42). Picture is interrupted. The picture may be interrupted when the resolution of the recorded video signal switches. Press OUTPUT RESOLUTION to select a setting other than Auto or Source Direct (page 27). The subtitles cannot be switched. The subtitles cannot be switched for discs recorded on a DVD or BD recorder. Sound and picture are not Is Output Terminal properly Set Output Terminal properly (pages 23 and 51). synchronized. set? Is Lip Sync properly set? Adjust the amount of audio delay with the Lip Sync setting (page 41). • No sound is output. • Sound is not output properly. Is the disc played back in slow motion? No sound is output during slow motion play and forward and reverse scanning. Is the disc played back in fast forward or fast reverse? Are the audio cables properly • Connect the cable properly according to the connected devices connected? (page 18). • Insert the cable firmly and all the way in. Is the audio cable damaged? If the cable is damaged, replace it with a new one. Are the connected Read the operating instructions of the connected components and components (AV receiver or check the volume, input, speaker settings, etc. amplifier, etc.) properly set? 68 En