Pioneer BDP-V6000 Owner's Manual - Page 40

06 • Prog.Motion is disabled when Pure Cinema is set to On. Note • Black Setup has the effect only for pictures output from the VIDEO output terminals and signals output with a frame/field frequency of 60Hz. • This only affects the Dolby TrueHD, Dolby Digital Plus and Dolby Digital audio signals of BDs and DVDs. • When Auto is selected, the setting has the same • YNR, CNR, BNR and MNR have no effect on 1080/24p video signals output from the HDMI OUT terminal.  Closing the Video Adjust screen Press HOME MENU.  About Pure Cinema effect as High or Off for Dolby TrueHD signals, depending on the content. For Dolby Digital Plus and Dolby Digital, the setting has the same effect as Off. • Audio DRC affects the audio signals output from the following audio output terminals: - Analog audio signals output from the AUDIO OUT terminals. There are two types of video signals: • Video material - Video signals recorded at 25 or 30 frames/second - Linear PCM audio signals output from the DIGITAL OUT terminal or HDMI OUT terminal. • The effect may be weak for some discs. • Film material - Video signals recorded at 24 frames/ second Adjusting the output level of "Pure Cinema" uses signal processing suited for "film material" when converting 480i/576ior 1080i interlaced video signals into progressive video signals, resulting in clear picture reproduction without losing the quality of the material. the different speakers during BD/DVD playback (Channel Level) is displayed on the disc information screen when playing the "film material" pictures of BD-ROM, BD-R/-RE and DVD-Video discs (page 31). Caution • Channel Level of the speakers set to None or No at Speaker Setup cannot be adjusted (page 47). Adjusting the audio 1 During playback, display the TOOLS menu. Press TOOLS. TOP MENU TOOLS 2 Select and set Audio Adjust. Use / to select, then press ENTER. HOME MENU ENTER RETURN 3 Select and set Channel Level. Use / to select, then press ENTER. 4 Adjust the output level. Use / to select, / to adjust. Adjusting the Audio DRC The output levels of the L, C, R, SL, SR, SBL, SBR and SW Audio DRC (Dynamic Range Control) has the effect of playing loud sounds softly and soft sounds loudly. Adjust speakers can be adjusted within the range of -6.0 dB to +6.0 dB. the setting for example when viewing movies late at night and the dialogs are difficult to hear. L 0.0 dB C 0.0 dB 1 During playback, display the TOOLS menu. Press TOOLS. R 0.0 dB SR 0.0 dB SBR 0.0 dB SBL 0.0 dB SL 0.0 dB 2 Select and set Audio Adjust. Use / to select, then press ENTER. SW 0.0 dB 3 Select and set Audio DRC. Use / to select, then press ENTER. 5 Press ENTER to set. 4 Adjust the setting. Use / to switch between Off, Low, Medium, High and Auto. Note • The adjustment of Channel Level is only applicable to the sound output from AUDIO OUT.  Closing the Audio DRC screen • This cannot be adjusted when in the following cases: - Output Terminal is set to HDMI or DIGITAL Press ENTER or HOME MENU. AUDIO (page 51). - Audio Output Mode is set to 2 Channel 40 (page 43). En