Pioneer BDP-V6000 Owner's Manual - Page 47

 Changing the speaker setup  Adjusting the distance of the 07 Set whether or not speakers are connected to an AV different speakers receiver or amplifier, etc., their size and their crossover frequency. This setting is only valid for the AUDIO OUT terminals. Adjust the distance between you and the different speakers. This setting is only valid for the AUDIO OUT terminals. When there are no speakers whose speaker size is set to Small, select Bypass for the crossover frequency. When there are speakers whose speaker size is set to Small, select the crossover frequency (Bypass cannot be selected). Caution • This cannot be selected when Audio Output Mode is set to 2 Channel. Change the setting to Multichannel (page 43). Caution • The Speaker Setup cannot be selected when Audio Output Mode is set to 2 Channel. Change the setting to Multi-channel (page 43). 1 Select and set Speakers  Speaker Setup  Next Screen. Use / to select, then press ENTER. • Speaker Distance of the speakers set to None or No at Speaker Setup cannot be adjusted (above). 1 Select and set Speakers  Speaker Distance  Next Screen. Use / to select, then press ENTER. 2 Select the speaker and adjust the distance. Use / to select, then use / to adjust. 2 Select the speaker and change the setting. Use / to select, then use / to change the setting. L/R C SL/SR SBL/SBR SW Crossover Speaker Setup BD PLAYER Large Large Large Large Yes Bypass Speaker Distance BD PLAYER L 10'00" C 10'00" R 10'00" SR 10'00" SBR 10'00" SBL 10'00" SL 10'00" SW 10'00" • The distance of all the speakers can be set to between 1 inch and 45 feet, in units of 1 inch. • L/R (front left and right speakers): Large/Small • C (center speaker): Large/Small/None • SL/SR (left and right surround speakers): Large/ Small/None • SBL/SBR (left and right surround back speakers): Large/Small/None  Adjusting the output level of the different speakers (Channel Level) Adjust each output level of the different speakers by using test tones. This setting is only valid for the AUDIO OUT terminals. • SW (subwoofer): Yes/No • Crossover: Bypass/50 Hz/80 Hz/100 Hz/150 Hz Note Caution • This cannot be selected when Audio Output Mode is set to 2 Channel. Change the setting to Multichannel (page 43). • Depending on the combination of settings of the different speakers, the settings of speakers other than the one you have changed may also change automatically. • When a subwoofer with a filter bypass function is connected and there is no speaker whose speaker size is set to Small, if the subwoofer's filter is set to be bypassed, the player's high precision digital filter is used. In this case, set the crossover frequency to something other than Bypass. • Channel Level of the speakers set to None or No at Speaker Setup cannot be adjusted (above). • Test tones are output. Lower the volume of the device connected to the player. 1 Select and set Speakers  Channel Level, then Fix or Variable. Use / to select, then press ENTER. • Fix - The output level of all the speakers is set to the maximum. • Upon purchase, the crossover frequency is set to Bypass. • Variable - The output level of all the speakers is set 6.0 dB lower than when Fix is selected. From this point, the output levels of the L, C, R, SL, SR, SBL, SBR and SW speakers can be adjusted within the range of -6.0 dB to +6.0 dB. If you have selected Variable, proceed to step 2. 47 En