Pioneer BDP-V6000 Owner's Manual - Page 21

Connecting video and Connecting an AV receiver or 03 audio cables amplifier using audio cables Note • Make the settings in the Setup Navigator menu according to the type of cable connected (page 23). • To output video signals from this player, connect using one of the following (not including when connected using an HDMI cable): a component video cable or a video cable. When connecting to a 7.1-channel compatible AV receiver or amplifier - Connect using 4 audio cables (diagram below). When connecting to a 5.1-channel compatible AV receiver or amplifier - Connect using 3 audio cables (do not connect to the surround back left and right terminals). • To switch the video from the AV receiver or amplifier, also connect the video output terminals. Connecting a TV using a video/audio cable • After connecting, set Audio Output Mode to Multichannel (page 43). Player's rear panel Video/audio cable (included) Audio cable (commercially available) Audio cable (commercially available) Audio cable (commercially available) Caution • Connect the player's video output directly to your TV. This player supports analog copy protection technology. Therefore the picture may not be displayed properly if connected to a TV via a DVD recorder/video deck or when playing the player's output material that is recorded by a DVD recorder/ video deck. Furthermore, the picture may not be displayed properly due to the copy protection when the player is connected to a TV with a built-in video deck. For details, contact the manufacturer of your TV. An optical digital audio cable (commercially available) can also be used for connection. DIGITAL OUT OPTICAL VIDEO COMPONENT VIDEO CENTER SUB WOOFER OUT Y VIDEO L PB L R PR R CONTROL IN FRONT SURROUND SURROUND AUDIO OUT(7.1 ch) BACK White Red Video/audio cable (included) To multi-channel audio input terminals Player's rear panel Yellow White Red VIDEO COMPONENT VIDEO CENTER SUB WOOFER OUT Y VIDEO L PB L R PR R CONTROL IN FRONT SURROUND SURROUND AUDIO OUT(7.1 ch) BACK It is also possible to connect to an AV receiver or amplifier. Connect the audio signals using audio cables (7.1 channels) or an optical digital audio cable (below). TV To video/audio input terminals A component cable or three commercially available video cables can be used instead of the video cable (yellow plug) of the included video/audio cable for connection. To component video input terminals Direction of signal flow Note To optical digital audio input terminal AV receiver or amplifier Direction of signal flow Note • To connect to the 2-channel audio input terminals on a TV, etc., connect to FRONT (L/R). Connecting components to the USB port The data downloaded with the BD-LIVE function and the data used with the BONUSVIEW function when playing BD-ROMs can be stored on a device connected to the USB port (external storage). About USB (external storage) devices • Video signals are output with a resolution of 480/60i or 576/50i when connected using a video cable. • When connected to the TV using a component video cable, video signals are not output with a resolution of 1080/60p, 1080/24p 1080/50i, 1080/50p or 720/50p. • Depending on the output video resolution setting, the picture may not be output (page 27). The USB (external storage) devices that can be connected to the player are as shown below. • USB 2.0-compatible memory devices or hard disks • FAT16 or FAT32 file system, minimum 1 GB capacity (2 GB or more recommended) 21 En