Pioneer BDP-V6000 Owner's Manual - Page 72

09 Others Problem Check Remedy Player cannot be restored to the factory defaults. Player cannot be controlled by RS-232C. Is a disc loaded in the player? Remove the disc from the player before restoring the player to the factory defaults (page 51). Check the Advanced Setup  Baud Rate setting and the serial interface specifications (page 56 and 58). The player's power turns off Is Auto Power Off set to automatically. On? If Auto Power Off is set to On, the player's power turns off automatically if no operation is performed for over 30 minutes (page 46). Is Display Power Off set to On? The player's power may turn off together with the power of the TV connected to the HDMI OUT terminal. If you do not want the player's power to turn off when the TV's power is turned off, set Display Power Off to Off (page 44). The player's power turns on Is KURO LINK set to On? automatically. The player's power may turn on together with the power of the TV connected to the HDMI OUT terminal. If you do not want the player's power to turn on when the TV's power is turned on, set KURO LINK to Off (page 44). Player cannot be operated with remote control. Is an AV receiver or amplifier Operate with the remote control of the device connected to the connected to the CONTROL CONTROL IN terminal. IN terminal on the player's rear panel? Are you operating the remote Operate from within 23 feet (7 m) of the remote control sensor. control from a point too far away from the player? Are the batteries dead? Replace the batteries (page 7). Is the RC-232C Key Lock command set? Cancel the Key Lock command. For details, see the communications interface user's manual. Black screen is displayed though no operations are being performed. Is Screen Saver set to On? • The screensaver turns off when the player's front panel or remote control is operated. • If you do not want the screensaver to be activated, set Screen Saver to Off (page 46). Front panel display does not Has the front panel display Press FL DIMMER on the remote control to switch the front panel turn on. been turned off? display's brightness (page 12). Buttons on the player's front Is Front Key Lock set to All Set Front Key Lock to Off (page 55). panel cannot be operated or or Tray? the disc tray does not open. Input of connected TV and AV Is KURO LINK set to On? system switches automatically. The input of the TV and AV system (AV receiver or amplifier, etc.) connected to the HDMI OUT terminal may automatically switch to the player when playback starts on the player or the menu screen (Home Media Gallery, etc.) is displayed. If you do not want the inputs of the connected TV and AV system (AV receiver or amplifier, etc.) to switch automatically, set KURO LINK to Off (page 44). "Processing failed." is displayed. If the message appears repeatedly, please ask your nearest Pioneer authorized service center or your dealer to carry out repair work. Settings you have made have • Have you disconnected the Always press  STANDBY/ON on the player's front panel or been cleared. power cord while the player's  STANDBY/ON on the remote control and check that POWER OFF power was on? has turned off from the player's front panel display before • Has there been a power failure? disconnecting the power cord. Be particularly careful when the power cord is connected to the AC outlet on another device because the player turns off in conjunction with the device. 72 En