Pioneer DJM-2000NXS Operating Instructions - Page 13

English r ON/OFF button (page 19) s LIVE SAMPLER (UTILITY, WAKE UP) buttons (page 18, page 28) t SYNC MASTER/MIDI button (page 20) u MIX button (page 16) v REMIX button (page 17) w ON/OFF button (TOUCH PANEL EFFECT) (page 16) x Crossfader (page 13) y MASTER control (page 13) z Master Level Indicator (page 13) A BALANCE control (page 15) B MONO, STEREO selector switch (page 15) C BOOTH MONITOR control (page 15) D START/STOP (SNAPSHOT) button (page 20) E ON/OFF (MIDI) button (page 20) F CH EQ (ISOLATOR, EQ) selector switch (page 13) G CH FADER ( , ) selector switch (page 14) H CROSS FADER ( , , ) selector switch (page 14) Do not pull on the channel fader and crossfader knobs with excessive force. The knobs have a structure by which they cannot be pulled off easily. Pulling the knobs strongly may result in damaging the unit. Basic Operation Outputting sound 1 Press [POWER] button. Turn on the power of this unit. 2 Switching the [CD/DIGITAL, PHONO, LINE, USB */*] switch Selects the input sources for the different channels from among the devices connected to this unit. - [CD/DIGITAL]: Selects the DJ player connected to the [CD] terminals. To select the DJ player connected to the [DIGITAL IN] terminal, set the [CD, DIGITAL] switch on the rear panel to [DIGITAL]. - [PHONO]: Selects the analog player connected to the [PHONO] terminals. - [LINE]: Selects the cassette deck or CD player connected to the [LINE] terminals. - [USB */*]: Selects the sound of the computer connected to the [USB] port. 3 Turn the [TRIM] control. Adjusts the level of audio signals input in each channel. The corresponding channel level indicator lights when audio signals are being properly input to that channel. 4 Move the channel fader away from you. Adjusts the level of audio signals output in each channel. 5 Switch the [CROSS FADER ASSIGN (A, THRU, B)] switch. Switches the output destination of each channel. - [A]: Assigns to [A] (left) of the crossfader. - [B]: Assigns to [B] (right) of the crossfader. - [THRU]: Selects this when you do not want to use the crossfader. (The signals do not pass through the crossfader.) 6 Set the crossfader. This operation is not necessary when the [CROSS FADER ASSIGN (A, THRU, B)] selector switch is set to [THRU]. 7 Turn the [MASTER] control. Audio signals are output from the [MASTER1] and [MASTER2] terminals. The master level indicator lights. Adjusting the sound quality Turn the [EQ/ISO (HI, MID, LOW)] controls for the respective channels. Refer to Specifications on page 32 for the range of sound that can be adjusted by each control.  Switching the function of the [EQ/ISO (HI, MID, LOW)] controls Switch the [CH EQ (ISOLATOR, EQ)] selector switch. - [ISOLATOR]: The isolator function is set. The indicator lights. - [EQ]: The equalizer function is set. En 13