Pioneer DJM-2000NXS Operating Instructions - Page 7

English Connections Be sure to turn off the power and unplug the power cord from the power outlet whenever making or changing connections. Refer to the operating instructions for the component to be connected. Connect the power cord after all the connections between devices have been completed. Be sure to use the included power cord. Rear panel 12 345 6 375 8 9 6 3 7 52 345 a OFF POWER ON l CH4 PHONO CD L SIGNAL GND CH 3 LINE CD L AC IN CD DIGITAL CONTROL CD DIGITAL R R MASTER1 MASTER2 REC OUT R L L MASTER ATT. -6dB -3dB 0dB R 1GND 2HOT 3COLD OUT BOOTH TRS R L k ji h g DIGITAL CH4 CH3 IN CH2 CH1 CH2 LINE CD L CH 1 PHONO CD SIGNAL GND L CONTROL CD DIGITAL CD DIGITAL SEND R L(MONO) R RETURN R L(MONO) LINK CH 3 CH 1 R COMPUTER 1 MIDI OUT USB CH 4 CH 2 COMPUTER 2 f e d c b 1 POWER button (page 13) Turns this unit's power on and off. 2 PHONO terminals (page 8) Connect to a phono level (MM cartridge) output device. Do not input line level signals. 3 CD terminals (page 8) Connect to a DJ player or a line level output component. 4 SIGNAL GND terminal (page 8) Connects an analog player's ground wire here. This helps reduce noise when the analog player is connected. 5 CD, DIGITAL (page 13) Selects the analog signal input terminals (CD) or the digital signal input terminals (DIGITAL IN). 6 LINE terminals (page 8) Connect to a cassette deck or a line level output component. 7 CONTROL (page 8) Connect using a control cord (included with Pioneer DJ players). 8 DIGITAL OUT terminal (page 8) Outputs the master channel audio signals. 9 DIGITAL IN terminal (page 8) Connect these to the digital coaxial output terminals on DJ players, etc. The sound may be momentarily interrupted when the output signal sampling frequency is switched. a Kensington security slot b USB (page 9) Connect to a computer. c MIDI OUT terminal (page 8) Connects this to the MIDI IN terminal on an external MIDI sequencer. d LINK terminal (page 8) Connect these to the LINK terminals on Pioneer DJ players or the LAN ports of computers on which rekordbox is installed (PRO DJ LINK). When connecting a LAN cable, be sure to use an STP (shielded) cable. e RETURN terminals (page 8) Connect to the output terminal of an external effector. When the [L (MONO)] channel only is connected, the [L (MONO)] channel input is simultaneously input to the [R] channel. f SEND terminals (page 8) Connect to the input terminal of an external effector. When the [L (MONO)] channel only is connected, a monaural audio signal is output. g BOOTH terminals (page 8) Output terminals for a booth monitor, compatible with balanced or unbalanced output for a TRS connector. h REC OUT terminals (page 8) These are output terminals for recording. i MASTER2 terminals (page 8) Connect to a power amplifier, etc. j MASTER ATT. Sets the attenuation level of the sound output from the [MASTER1] and [MASTER2] terminals. k MASTER1 terminals (page 8) Connect to a power amplifier, etc. Be sure to use these as balanced outputs. Be careful not to accidentally insert the power cord of another unit. l AC IN Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the power cord. Be sure to use the included power cord. WARNING The short-circuit pin plugs out of the reach of children and infants. If accidentally swallowed, contact a doctor immediately. En 7