Pioneer DV-440 Owner's Manual - Page 27
DTS Out, kHz PCM Out, Digital Out, MPEG Out
View all Pioneer DV-440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
DTS Out This player is capable of outputting DTS digital audio for DVDs recorded in DTS. When this player is connected to an AV component that has a built-in DTS decoder, select [DTS]. If your system is not equipped to decode DTS, select [Off]. Refer to the operating instructions supplied with your audio components if you are unsure about compatibility with DTS. Audio1 A2 Video1 V2 Language General Audio DRC - Off Dolby Digital Out - Dolby Digital DTS Out - Off 96kHz PCM Out DTS MPEG Out - MPEG 3 PCM Change DTS output mode Move Settings: Off* DTS SETUP Exit *Factory setting Note If you have made digital audio connections to component(s) not equipped to decode the DTS digital bitstream, be sure to select [Off]. If a DTS signal is output without decoding, the output is digital noise that could potentially cause damage to your speakers. 96 kHz PCM Out This player is capable of outputting digital signals with a sampling frequency of 96 kHz. If you have made connections to a component capable of processing this signal rate, select [96 kHz] for the signal to be output as is. As some components are incapable of processing digital signal input with sampling rates of 96 kHz, selecting [96 kHz 3 48 kHz] compresses the signal to a standard signal with a sampling rate of 48 kHz. Audio1 A2 Video1 V2 Language General Audio DRC - Off Dolby Digital Out - Dolby Digital DTS Out - Off 96kHz PCM Out - 96kHz 3 48kHz MPEG Out 96kHz Change 96kHz output mode Move SETUP Exit Settings: 96 kHz 3 48 kHz* 96 kHz *Factory setting Note On DVDs that contain copy protection, the 96 kHz signal may only be output from the analog audio jacks. MPEG Out This player is capable of outputting the MPEG digital bitstream. When the player is connected to an AV component that has a built-in MPEG decoder, select the [MPEG] setting. Otherwise, select [MPEG 3 PCM] to convert the digital signal to the PCM signal, the digital signal output from a CD. Audio1 A2 Video1 V2 Language General Audio DRC - Off Dolby Digital Out - Dolby Digital DTS Out - Off 96kHz PCM Out - MPEG MPEG Out - MPEG 3 PCM Change MPEG audio output mode Move SETUP Exit Settings: MPEG MPEG 3 PCM* *Factory setting Digital Out Expert - DVD/Super VCD/VCD/CD Depending on your preferences and the type of connections made, you may opt not to have the digital audio signal output at all. When this setting is set to [Off] there is no signal output from the digital audio output jacks. Make changes to the [Digital Out] setting in the Setup screen Audio 1 menu in the [Expert] menu mode (page 25). Audio1 A2 Video1 V2 Language General Audio DRC - Off Dolby Digital Out - Dolby Digital DTS Out - Off 96kHz PCM Out - 96kHz 3 48kHz MPEG Out - MPEG 3 PCM Digital Out - On Off Move SETUP Exit Settings: On* (Digital bitstream is output) Off (Digital bitstream is not output) *Factory setting ADJUSTING AUDIO AND VIDEO SETTINGS 27 En