ProForm 400 H Elliptical English Manual - Page 10

9. The Console (10) requires four "D" batteries (not included); alkaline batteries are recommended. Remove the battery cover from the back of the Console and insert four batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compartment. Then, reattach the battery cover. Have a second person hold the Console (10) near the Upright (2) as shown. Connect the console wire to the Upper Wire Harness (18). Attach the Console (10) to the Upright (2) with four M4 x 16mm Screws (60). Be careful to avoid pinching the wires. Note: The Console (10) can be operated with an optional power supply instead of batteries. To purchase a power supply, call the tollfree telephone number on the front cover of this manual. Plug one end of the power supply into the jack on the elliptical exerciser. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. 10. Identify the Left Upper Body Arm (4), which is marked with a "Left" sticker. Orient the Left Upper Body Arm so that the indicated tube is facing inward. Lubricate the upper end of the left Upper Body Leg (6) using a small amount of the included high-temperature lubricant. Then, slide the Left Upper Body Arm (4) onto the Upper Body Leg. Apply a generous amount of grease to the Pivot Axle (16). Also, apply a small amount of grease to a Wave Washer (27). Then, insert the Pivot Axle through the Left Upper Body Arm (4), an Upper Body Arm Spacer (29), the Wave Washer, and the Upright (2). Make sure that the Upper Body Arm Spacer is oriented as shown, with the arrow pointed downward. 9 Battery Cover Batteries 10 10 Console Wire 60 2 18 Avoid pinching the wires during this step 10 4 2 Grease 16 Grease Tube 27 Arrow 29 Lubricate 6 10