ProForm 420 Zle Elliptical Uk Manual - Page 12

12. Identify the Left Upper Body Arm (8) and the Left Upper Body Leg (11), which are marked with 12 “"Left”" stickers, and orient them as shown. Insert the Left Upper Body Arm (8) into the Left Upper Body Leg (11). Attach the Left Upper Body Arm (8) with two M8 x 41mm Bolts (78) and two M8 Jam Nuts (79). Make sure that the Jam Nuts are in the hexagonal holes in the Left Upper Body Leg (11). 9 8 Attach the Right Upper Body Arm (9) to the Right Upper Body Leg (12) in the same way. Hexagonal 79 Holes 78 79 78 12 11 13. Using a small plastic bag to keep your fingers clean, apply a generous amount of the 13 included grease to the Pivot Axle (74) and to two Wave Washers (111). Insert the Pivot Axle (74) into the Upright (3) and center it. 88 84 3 Slide a Wave Washer (111) onto each end of the Pivot Axle (74). Orient the Left Upper Body Leg (11) as shown, and slide it onto the left end of the Pivot Axle (74). Slide the Right Upper Body Leg (12) onto the right end of the Pivot Axle. At the same time, tighten an M8 x 23mm Screw (84) with an M8 Washer (88) into each end of the Pivot Axle (74). Grease 74 111 88 84 11 111 12 12