ProForm 420 Zle Elliptical Uk Manual - Page 14

16. Apply a small amount of grease to one of the Pedal Arm Axles (32). Tighten an M8 x 23mm Shoulder Screw (115) with an M8 Washer (88) and a Pedal Arm Cover (31) a few turns into the Pedal Arm Axle (32). While a second person holds the front end of the Left Pedal Arm (14) inside the bracket on the Left Upper Body Leg (11), insert the Pedal Arm Axle (32) into both parts. Next, tighten an M8 x 23mm Shoulder Screw (115) with an M8 Washer (88) and a Pedal Arm Cover (31) a few turns into the Pedal Arm Axle (32). Tighten both Shoulder Screws at the same time; to avoid damaging the Pedal Arm Covers, do not overtighten the Shoulder Screws. Repeat this step to attach the Right Pedal Arm (not shown) to the Right Upper Body Leg (12). 16 11 31 88 12 31 88 115 115 32 Grease 14 17. Lift the latch on the underside of the Left Pedal Arm (14), and set the Left Pedal Arm on the left 17 Crank Bushing Sleeve (43). Release the lever, and make sure that the Left Pedal Arm (14) is securely connected to the Crank Bushing Sleeve (43). Connect the Right Pedal Arm (not shown) in the same way. See step 5. Tighten the M8 x 69mm Bolt (80) and the two M8 x 23mm Screws (84). 14 Latch 43 18. Make sure that all parts of the elliptical are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical. 14