ProForm 420 Zle Elliptical Uk Manual - Page 22

Maintenance And Troubleshooting

Page 22 highlights

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HOW TO LEVEL THE ELLIPTICAL If the elliptical rocks slightly on your floor during use, turn one or both of the leveling feet beneath the rear stabilizer until the rocking motion is eliminated. CONSOLE TROUBLESHOOTING If the console displays become dim when batteries are installed in the console, replace the batteries; most console problems are the result of low batteries. See assembly step 9 on page 10 for replacement instructions. Base Foot If the handgrip heart rate monitor does not function properly, see step 5 on page 19. Leveling Feet HOW TO ELIMINATE FLEXING IN THE CENTER OF THE ELLIPTICAL If the elliptical flexes in the center during use, turn the base foot (see the drawing above) until the flexing is eliminated. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

22
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap.
IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console displays become dim when batteries
are installed in the console, replace the batteries;
most console problems are the result of low batteries.
See assembly step 9 on page 10 for replacement
instructions.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 19.
HOW TO LEVEL THE ELLIPTICAL
If the elliptical rocks slightly on your floor during use,
turn one or both of the leveling feet beneath the rear
stabilizer until the rocking motion is eliminated.
HOW TO ELIMINATE FLEXING IN THE CENTER OF
THE ELLIPTICAL
If the elliptical flexes in the center during use, turn the
base foot (see the drawing above) until the flexing is
eliminated.
MAINTENANCE AND TROUBLESHOOTING
Leveling
Feet
Base
Foot