ProForm 420 Zle Elliptical Uk Manual - Page 8

4. Hold a Hub Cover (75) and a Crank Arm (36) against the Crank (45). 4 Align the holes in the Hub Cover (75) and the Crank Arm (36) with the unused holes in the left side of the Crank (45). Insert four Hub Screws (87) into the Hub Cover (75) and the Crank Arm (36), and finger tighten the Hub Screws into the Crank (45). Tighten one Hub Screw, and then tighten the Hub Screw across from the first Hub Screw. Then, tighten the remaining two Hub Screws. 43 98 36 45 Repeat this step on the right side of the elliptical. Make sure that the Crank Arms (36) are oriented with the Crank Bushing Sleeves (43) in the positions shown. Note: There are no Pulley Screws (98) on the right side. 36 75 87 87 43 5. While a second person holds the Upright (3) near the Base (1), connect the Upper Wire 5 Harness (48) to the Lower Wire Harness (49). Tip: Avoid pinching the wires. Insert the Upright (3) into the Base (1). Attach the Upright (3) with an M8 x 69mm Bolt (80), an M8 Split Washer (90), and an M8 Jam Nut (79). Do not tighten the Bolt yet; make sure that the Jam Nut is in the hexagonal hole in the Base. Next, finger tighten two M8 x 23mm Screws (84) and two M8 Split Washers (90) into the Base (1). Do not tighten the Screws yet. Attach the Water Bottle Holder (22) to the Base (1) with two M4 x 16mm Blunt Screws (104). 80 90 90 84 Avoid pinching the wires 3 48 49 79 90 84 104 22 1 8