ProForm 650 English Manual - Page 12

20. Wrap the Leg Press Cable (76) around a 4" 20 Pulley (35). Attach the Pulley and a Cable Trap (44) to the bracket on the Stabilizer (5) with a 3/8" x 2" Bolt (62) and a 3/8" Nylon Locknut (50). Be sure that the Cable Trap (44) is positioned to hold the Cable in the pulley groove. 62 35 76 Bracket 44 5 50 21. Remove the pre-assembled 4" Pulley (not shown) 21 from the Pulley Bracket (91). Attach the end of the Leg Press Cable (76) to the Pulley Bracket (91) with a 1/4" Washer (71) and a 1/4" Nylon Locknut (25). Lay the Pulley Bracket (91) and the Leg Press Cable (76) aside; they will be attached in step 29. 25 91 71 76 22. Locate the High Cable (73). Feed the bolt end of 22 the High Cable up through the indicated slot in the Main Upright (3). Feed almost all of the Cable through the slot. Slide a 3/8" Washer (55) and a 5/8" x 1/2" Bushing (42) onto a 3/8" x 2 1/2" Bolt (54). Wrap the High Cable (73) around a 4" Pulley (35). Hold the Pulley inside the indicated slot in the Main Upright (3). Insert the 3/8" x 2 1/2" Bolt (54) through the Main Upright and the Pulley. Slide another 5/8" x 1/2" Bushing (42) and 3/8" Washer (55) onto the 3/8" x 2 1/2" Bolt (54). Tighten a 3/8" Nylon Jamnut (63) onto the Bolt. 73 35 3 42 63 55 Slot 54 55 42 12