ProForm 650 English Manual - Page 16

33. Attach a 4" Pulley (35) over the Low Cable (72), 33 inside the front leg of the Base (8) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Washers (55), two 5/8" x 1/2" Bushings (42), and a 3/8" Nylon Jamnut (63). 8 72 35 34. Route the Low Cable (72) through the indicated slot in the Main Upright (3) and the Base (8). Wrap the Low Cable (72) around a 4" Pulley (35) in the direction shown. Attach the Pulley inside the bracket on the Main Upright (3) with a 3/8" x 2" Bolt (62) and a 3/8" Nylon Locknut (50). 63 42 55 34 50 35 62 72 Bracket 55 54 42 3 Slot 35. Wrap the Low Cable (72) over a 4" Pulley (35). 35 Slide the Pulley and a Cable Trap (44) between the two Pulley Plates (31). Make sure the Cable is in the groove of the Pulley and that the Cable Trap is oriented so it will hold the Cable in place. Attach the 4" Pulley (35) and the Cable Trap (44) to the third set of holes from the bottom of the Pulley Plates (31) with a 3/8" x 1 3/4" Bolt (60) and a 3/8" Nylon Jamnut (63). 8 31 60 44 63 35 72 36. Wrap the Low Cable (72) around a 4" Pulley (35). 36 Attach the Pulley inside the bracket on the Main Upright (3) with a 3/8" x 2" Bolt (62) and a 3/8" Nylon Locknut (50). 72 35 62 3 50 16