Ryobi RLS1351 Operation Manual - Page 9
Features - flooring saw manual
View all Ryobi RLS1351 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
FEATURES PRODUCT SPECIFICATIONS Blade Diameter 5 in. Blade Arbor 5/8 in. Rip Capacity 8 in. Miter Capacity 11 in. Input 120 V~, 60 Hz, 7 Amps No Load Speed 11,000 r/min. (RPM) KNOW YOUR flooring saw See Figure 1, page 17. The safe use of this product requires an understanding of the information on the tool and in this operator's manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. 5 in. BLADE - A 5 in. blade is included with the saw. It will cut materials up to 3/4 in. thick. WARNING: Do not use blades rated less than the speed of this tool. Failure to heed this warning could result in personal injury. ANTI-KICKBACK PAWLS (for use with rip cuts) - Kickback is a hazard in which the workpiece is thrown back toward the operator. The teeth on the anti-kickback pawls point away from the workpiece. If the workpiece should be pulled back toward the operator, the teeth dig into the workpiece to help prevent or reduce the possibility of kickback. BLADE GUARD - Always keep the blade guard down and over the saw blade for all cuts. BLADE GUARD ADJUSTMENT KNOB - Set the clearance of the workpiece using the blade guard adjustment knob. Clearance between the workpiece and blade guard should be set between 1/16 in. - 3/32 in. BLADE WRENCH STORAGE - A blade wrench is packed with the saw. One end of the wrench is a phillips screwdriver and the other end is a hex key. Use the hex key end when installing or removing blade and the phillips end when removing or loosening screws. A storage area for the blade wrench is located under the saw's table. Carrying Handle - For convenience when carrying or transporting the saw from one place to another, a carrying handle has been provided on the side of the saw. FENCE - The fence attaches to the saw table and can be angled for miter cuts as well as placed straight for rip cuts. With the locator pin in place, the clamp knob locks the fence to the table at the desired cutting angle. MITER GROOVE - The attachment bolt rides in the miter groove on the saw table to secure the fence in place when making miter cuts. ON/OFF SWITCH - This saw has an easy access power switch located on the front of the saw. To lock the switch in the OFF position, remove the switch key from the switch. Place the key in a location that is inaccessible to children and others not qualified to use the tool. RIP GROOVES - The attachment bolt rides in the rip groove on the saw table to secure the fence in place when making rip cuts. RIVING KNIFE - A metal piece, slightly thinner than the saw blade which helps keep the kerf open and prevent kickback. 9