Samsung LN32A620A1F User Manual (user Manual) (ver.1.0) (English, Spanish) - Page 122

Connecting the Data Cable Clone Remote Control TV Rear Panel Features Copying the TV Data to the Clone remote - Set up the TV Install Data. - Connect the cable between the TV and the Clone remote as shown in the figure. ➣ When using the Auto Wall-Mount: Use the Clone Remote Control only after disconnecting the Auto Wall-Mount cable. - If you press the Receive button of the Clone remote transmitter, the OSD shown in the figure is displayed and the copy operation begins. - Wait until the OSD progress bar reaches 100% and data transmission is complete. Clone Remote Processing Please Wait !!! TV ----------> CLONE 62% Copying the Clone remote Data to the TV (You can copy data through the cable.) - Press the SEND button to start copying. ➣ If there is a communication interruption during the processing download or upload, press the same button(send or receive) to EXIT processing and try again. - Turn on the TV where the Clone remote Data will be copied to. - The copy operation begins showing the OSD as shown in the figure to the right. - Wait until the OSD progress bar reaches 100% and the data transmission is complete. Clone Remote Processing Please Wait !!! CLONE ----------> TV 54% Warning concerning Clone remote operation - If an error occurs when transmitting data to the Clone remote, you should transmit it again. Please turn the AC power off and on after copying data. - During data transmission, be sure not to disconnect the Data cable. - Data can only transmitted by the Clone remote when Hotel mode is on. English - 120