Sanyo AWM-2800 Instruction Manual - Page 14

LISTENING TO THE RADIO FREQUENCY UP/DOWN TUNING Automatic tuning TO PRESET STATIONS Up to 24 FM and 12 AM stations can be preset. PI 51 0 2 O 1. Press [BAND] to select AM or FM. • "TU" blinks on the display, then "TU" is replaced by the tuner mode display. BAND 2. Press [TUNING +] or [TUNING -] for at least 1 second to tune in a station. The unit will scan up or down the band and select the next receivable station. Press the button again to continue. TUNING st I sr 3 O 2,4 1. Tune in the station to be preset as described in "Automatic tuning" or "Manual tuning". 2. Press [MEMORY]. MEMORY \ 1/ MEMORY In „ I LJ J. I LJ z 3. Press [PRESET] A or V (or press [PRESET] + or - on the remote control) to select the channel number to be preset while "CH" and "MEMORY" are blinking. PRESET \,,„ 1 / \MEMIci unn in7 in \ Manual tuning 1. Press [BAND] to select AM or FM. 2. Press [TUNING +] or [TUNING -] continuously until you are close to the desired frequency, then press it briefly until the desired frequency is displayed. Each time the button is pressed, the frequency changes in 200 kHz steps for FM and 10 kHz steps for AM. Il-- NI II I I- 1 -1 IUD I 17 lU m" • The number buttons on the remote control can also be used. 4. Press [MEMORY] within 3 seconds. • In this example, "103.1 MHz" FM station is preset on FM channel number 9. • The number buttons on the remote control can be used to preset the station directly. In this example, press 9 after the step 2 above. MEMORY v in 7 in I- I I IUD. lU mHz 5. Repeat the steps above to add more preset stations. When presetting a new station, the previously preset station on the same program number of the same band is cleared. • The preset stations will be retained in the memory even if the unit is turned off. • If the memory contents are lost due to a power failure or other condition, program the stations again. -E13-