Sanyo PLC-XK2600 RS232 Expand - Page 20

PLC-XK2200 /2600 /XK3010 Expand Serial Command Functional Specifications 8.4.8 CF_WBAL - Command Command "CF_WBAL-%1_%2"[CR] "R Red %1 "G Green "B Blue "000~063 Directly select Color value specified by White Balance%1 %2 "UP Current Color value set by White Balance%1 + 1 "DN Current Color value set by White Balance%1 - 1 Details Set Color value set by White Balance%1 of user control Projector does not save the value set with this command so that it resets when projector turning into Standby status or ALL is OFF. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.9 CF_COLTEMP Command Command "CF_COLTEMP_%1"[CR] "000" ------ Xlow %1 "001" ------ Low "002" ------ Mid "003" ------ High Details Set Color Temperature. (Available only in the normal Power ON status) The value set by this command will not be saved to the projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.10 CF_PROGV Command Command "CF_PROGV_%1"[CR] "FILM" -------- Select Progressive Mode FILM "L1 Select Progressive Mode L1 %1 "L2 Select Progressive Mode L2 "OFF" --------- Cancel Progressive scan "UP The same operation as pressing Up key or Left key "DN The same operation as pressing Down key or Right key Details Set / cancel Progressive scan Projector does not save the value set with this command so that it resets when projector turning into Standby status or ALL is OFF. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 20 / 73