Sharp DT-200L Operation Manual - Page 13

Setup & Connections Connections Power Supply Connecting the Power Cord Plug the supplied power cord into the AC socket on the back of the projector. Power cord CAUTION • Make sure the power cord is firmly connected into the AC socket. • The projector will enter the standby mode as you re-plug it into the AC socket, when unplugging the power cord after turning the power off by pressing the POWER button. However, if the projector was turned off by disconnecting the power cord or by a power failure, the projector will automatically turn on when plugging the power cord again. Connecting to Video Equipment You can connect your projector to a VCR, laser disc player, DVD player, DTV* decoder and other video equipment. * DTV is the umbrella term used to describe the new digital television system in the United States. CAUTION • Make sure to turn both the projector and the video equipment off, before connecting. • As this projector is not equipped with audio input terminals, commercially available audio equipment or your own equipment (such as speakers or amplifiers) should be used. Connecting a video source (VCR, laser disc player, DVD player or DTV decoder) using the INPUT 3 S-VIDEO and INPUT 4 VIDEO terminals 1 Connect one end of the S-video cable (commercially available) to the INPUT 3 S-VIDEO terminal, or one end of the video cable to the INPUT 4 VIDEO terminal on the projector. 2 Connect the other end of the S-video cable or the video cable to the S-video output or Video output terminal of the video source. The S-video input terminal uses a video signal system where the picture is separated into a color and luminance signal to realize a higher-quality image. • For higher quality video, you may use the S-video input terminal on the projector. An S-video cable is commercially available. • If your video equipment does not have an S-video output terminal, use the composite video output terminal. DT-200(E)#p12_14.p65 12 02.11.21, 11:29 AM E-12