Sharp DT-200L Operation Manual - Page 15

Setup & Connections Connecting to a DVD Player and DTV Decoder Connecting to a DTV decoder with DVI output 1 Slide the "DIGITAL INPUT TYPE" switch on the back terminal board to "VIDEO". 2 Connect the DVI cable to the DIGITAL INPUT terminal. 3 Connect the other end to the Corresponding terminal on a DVD player and DTV decorder. When connecting this projector to analog RGB output of the DTV decoder, select "Component" for "Signal Type" on the OSD menu or press RGB/COMP. on the remote control. (See page 36.) CAUTION • Make sure to turn both the projector and the video equipment off, before switching the "DIGITAL INPUT TYPE" swich and connecting. Projector DVI cable (commercially available) DTV decoder 2 3 1 Connecting to a DTV decoder with analog RGB output 1 Connect the DVI to 15-pin D-Sub adaptor. 2 Use the above cables to connect the projector and the DTV decoder. When connecting this projector to analog RGB output of the DTV decoder, select "Component" for "Signal Type" on the OSD menu or press RGB/COMP. on the remote control. (See page 36.) CAUTION • Make sure to turn both the projector and the video equipment off, before switching the "DIGITAL INPUT TYPE" swich and connecting. Projector DVI to 15-pin D-sub adaptor (sold separately AN-A1DV) DTV decoder Connecting to a Computer Connecting a computer with analog RGB output 1 Connect the DVI end of the DVI to 15-pin D-sub adapter to the INPUT 2 port on the projector. 2 Connect the D-sub end of the DVI to 15-pin D-sub adapter to the computer. When connecting this projector to a DVD player or DTV decoder, select "RGB" for "Signal Type" on the OSD menu or press RGB/COMP. on the remote control. (See page 36.) DVI to D-sub 15-pin cable 2 (sold separately AN-A1DV) 1 DT-200(E)#p12_14.p65 14 02.11.21, 11:30 AM E-14