Sharp FP-R65CX Operation Manual - Page 24

TROUBLESHOOTING Before calling for repair, please review the list below, since the problem may not be a unit malfunction. SYMPTOM The Remote Control does not work. Odours and smoke are not removed. REMEDY (not a malfunction) • Have the batteries been depleted? • Are the batteries inserted correctly? • Is a fluorescent lighting in the room flickering due to service life? • Clean or replace the filters if they appear to be heavily soiled. (Refer to E-19,E-20) The CLEAN-SIGN Light lights green even when the air is impure. • The air could be impure at the time the unit was plugged in. (Refer to E-14) The CLEAN-SIGN Light lights orange or red even when the air is clean. • The sensitivity of the sensors become unstable when the opening of the odour sensor or dust sensor is dirty or is clogged. Clean the dust around the sensor opening using a vacuum cleaner. (Refer to E-14) The Plasmacluster Indicator Light remains green (or blue) and does not change. • When in Clean Mode ( or Ion Control Mode), the Plasmacluster Indicator Light colour will not change. A clicking or ticking sound is heard from the unit. The discharged air has an aroma or odour. • Clicking sound is emitted when the unit is in the Ion Control Mode, and ticking sound is emitted when the unit is generating ions. If the sound is irritating, set the unit away from you. • Check to see if the filters are heavily soiled. Replace the filters. • Plasmacluster Air Purifiers emit small traces of ozone which may produce an odour. These ozone emissions are well below safety levels set by FDA. The unit does not operate when cigarette smoke is in the air. • Is the unit installed in a location that is difficult for the sensor to detect cigarette smoke? • Are the dust or odour sensor openings blocked or clogged? (In this case, clean the openings.) (Refer to E-20) The Active Carbon Filter Indicator Light or MIST Unit Indicator Light remains activated even after replacing filter. • After replacing filters, connect the power cord to an outlet and press associated Reset Button. (Refer to E-18,19) Care Cycle : Active Carbon Filter : 2 months MIST Filter : 1 month The Plasmacluster Indicator Light or the CLEAN-SIGN Light will not activate. Plasmacluster Indicator Light (mixture of blue and green) repeats the light/dark colour cycles. Mist Unit Indicator Light does not turn on even water is in. When the water of the tank does not decrease or the decrease of the water is slow. • Check to see if the Lights OFF Mode on the Remote Control is selected. If so, then press the Lights ON/OFF Button on the Remote Control to activate the indicator lights. (Refer to E-14) • The SENTINEL operation is working. SENTINEL Operation mode is turned on when pressing the ION AUTO or CLEAN button on the Remote Control. • Please check if the impurities adhered to the surface of the Float. Clean the Mist Tray. Check to see check if the Main Unit is put on a inclined surface. • Check to see if the Mist unit and Tank are installed correctly. • Check the Mist Filter. Replace the filter when it is heavily soiled. (Refer to E-18,21) E-22