Sharp HTSB200 HT-SB200 Operation Manual - Page 11

To mount the speaker on the wall Caution: ● Be very careful to prevent the speaker [3.86 lbs. (1.75 kg)] from falling when mounting on the wall. ● Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The speaker may fall.) If unsure, consult a qualified service technician. ● Mounting screws are not supplied. Use appropriate ones. ● Check all wall mount angle screws for looseness. ● Select a good location. If not, accidents may occur or the speaker may get damaged. ● SHARP is not responsible for accidents resulting from improper installation. ■ Driving screws SHARP designed the speakers so you may hang them on the wall. Use proper screws (not supplied). See below for size and type. 1/8" (3.2 mm) 3/16" (5 mm) 3/8" (9 mm) Min. 7/8" (22 mm) ■ Wall mount angle fixed to the wall (Horizontal position) 1 Fix the pattern paper to the wall in horizontal position as below. Wall surface 44 mm 509 mm 44 mm 29 mm HT-SB200 Preparation for Use 29 mm Pattern paper 2 Make a hole on the wall following the screw point marks on the pattern paper by using a drill. 1-1/4" (32 mm) 3/8" (8-9 mm) Wall surface 3 Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface. 1-1/4" (32 mm) 3/8" (8-9 mm) Wall surface Continued to the next page 11