Sharp LC-32DV22U LC-26DV22U LC-32DV22U Operation Manual - Page 36

Connecting a PC (Personal computer) Viewing an image from a PC Use the INPUT6 (PC) terminals to connect a PC. • LC-26DV22U/LC-26DV22U-W : INPUT5. NOTE • The PC input terminals are DDC1/2B-compatible. • Refer to page 35 for a list of PC signals compatible with the System. • Make sure to select the same signal values for the output signal of a PC and the input signal of the TV/DVD set before connecting with the PC. (See page 35.) • Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your PC's manuals regarding converting to external output. Connecting the RGB cable • Connect the RGB cable making sure that it fits correctly into the terminal. Then, firmly secure the connectors by tightening the screws on both sides of the plug. To Audio output terminals To AUDIO HDMI/PC input terminal ͌3.5 mm stereo minijack cable (commercially available) PC To ANALOG RGB RGB cable (commercially available) To PC IN output terminal terminal Signal names for 15-pin mini D-sub connecter 543 21 10 9 8 7 6 15 14 13 12 11 Pin No Signal name R G B Not connected CSYNC Pin No Signal name GND (Ground) GND (Ground) GND (Ground) +5V GND (Ground) Pin No NOTE • Pin No. 5 is not used for inputting the signal. • Pin No. 9 is not connected with the supplied RGB cable. Signal name Not connected SDA HD VD SCL Displaying an image from a PC To view an image from a PC, perform the following procedure. ① Select the INPUT6 (LC-26DV22U/LC-26DV22U-W : INPUT5) (PC) mode using INPUT on the remote control or the TV/DVD set. (See page 14.) ② Select the PC input signal. (See page 35.) ③ Adjust the "PICTURE." items if the PC image does not come in clearly. (See page 35.) SOURCE SELECTION 0. TV 1. INPUT1 2. INPUT2 3. INPUT3 4. INPUT4 5. INPUT5 6. INPUT6 [0-6]:SELECT 34