Sharp LC 42D43U Operation Manual - Page 14

Preparation - remote

Page 14 highlights

Preparation Use the remote control unit by pointing it towards the remote control sensor on the TV. Objects between the remote control unit and the remote control sensor may prevent proper operation. Do not expose the remote control unit to shock, in addition, do not expose the remote control unit to liquids, and do not place in an area with high humidity. ,, Do not install or place the remote control unit under direct sunlight. The heat may cause deformation of the remote control unit. ,, The remote control unit may not work properly if the remote control sensor on the TV is under direct sunlight or strong lighting. In such cases, change the angle of the lighting or the TV, or operate the remote control unit closer to the remote control sensor. J To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. _. A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools (Commercially available). F-type connector __- 75-ohm coaxial cable (round) f _ F=type connector should be finger= tightened only. When connecting the RF cable to the TV set, do not tighten F-type connector with tools. If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.) 2. A 300-ohm system is a flat "twinqead" cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter (Commercially available). F-type connector 3..0..0..-.o..h..m......twinqead cable (flat) ,,_ j 75-ohm coaxial cable J Connecting Antenna Cable Cable without a CATV converter HomeAntenna terminal (75 ohm) Ooa×ialeable (commeroial_y available} VHF/UHF antenna Combination VHF/ UHF antenna Home Antenna terminal/75 ohm) Ooa×ial cable (commeroial_y available} • Connect the antenna cable to the TV using one of the methods in the illustration as shown (_, _, @ or _}. Separate VHF/UHF antenna VHF UHF ANTENNA ANTENNA 300/75_hm adapter (oommemially available) To TV antenna terminal Q- 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61

Preparation
Use the remote control unit by pointing
it towards
the remote control sensor on the
TV. Objects between the remote control unit and the remote control sensor may
prevent proper operation.
Do not expose the remote control
unit to shock,
in addition,
do not expose the remote
control unit to liquids, and do not place in an area with high humidity.
,, Do not install or place the remote control
unit under direct sunlight. The heat may cause
deformation
of the remote control unit.
,, The remote control unit may not work
properly if the remote control sensor on the TV is
under direct sunlight or strong lighting. In such cases, change the angle of the lighting or
the TV, or operate
the remote control unit closer to the remote control sensor.
J
To enjoy a clearer picture, use an outdoor
antenna. The following is a brief explanation
of the types of connections
that are used for a coaxial cable. If your outdoor
antenna uses a 75-ohm
coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the TV set.
_.
A 75-ohm
system is generally a round
cable with F-type
connector
that can easily be attached
to a terminal
without
tools (Commercially
available).
F-type connector
__-
75-ohm
coaxial cable
(round)
2. A 300-ohm
system is a flat "twinqead"
cable that can be
attached
to a 75-ohm
terminal
through
a 300/75-ohm
adapter
(Commercially
available).
........................................................
_
300-ohm
twinqead
cable (flat)
,,_
j
f
_
F=type
connector
should
be finger=
tightened
only.
When connecting
the RF cable to the TV set, do not
tighten F-type connector
with tools.
If tools are used, it may cause damage to your TV
set. (The breaking of internal circuit, etc.)
F-type connector
75-ohm
coaxial cable
J
Connecting
Antenna
Cable
Cable
without
a
CATV
converter
VHF/UHF
antenna
Combination
VHF/
UHF antenna
Separate
VHF/UHF
antenna
HomeAntenna
terminal
(75
ohm)
Ooa×ialeable
(commeroial_y
available}
Home
Antenna
terminal/75
ohm)
Ooa×ial cable
(commeroial_y
available}
VHF
UHF
ANTENNA
ANTENNA
300/75_hm
adapter
(oommemially
available)
To TV
antenna
terminal
Connect
the antenna
cable
to the
TV
using one
of the
methods
in
the
illustration
as shown (_,
_,
@ or _}.
Q-
13