Sharp LC-60LE810UN LC-40LE810UN LC-46LE810UN LC-52LE810UN LC-60LE810UN - Page 37

On-Screen Display Menu ■ Updating the Software via the Network 1 Press c/d on the Manual Update screen to select "Network Update", and then press ENTER. • The TV connects to the network and checks for updates. • To cancel, press ENTER. Connecting to Internet.. Checking latest version of Firmware.. Accessing.. Abort 2 The current version of the TV and the latest version of firmware are displayed. To update the TV software, select "Yes", and then press ENTER. Latest version of firmware has been found. Firmware update is available. Proceed with update? Current Version XXXXXXXX Latest Version XXXXXXXX Estimated Update Time XX Select "Yes" to start update. Yes No • When a server connection cannot be established or an update is not available, a message is displayed. If a server connection cannot be established, check the broadband connection and Internet Setting. Cannot reach the server. Check the network settings and try again. OK There is no newer software than the present version. OK 3 After the update file is downloaded, the software update process begins. Downloading latest firmware.. Version : XXXXXXXX 4 When the software is successfully updated, a screen is displayed indicating that the update process is completed. Press ENTER. The TV restarts, and it takes a while until the system update is completed. Do not unplug the AC cord. Press "OK" to restart the TV and complete the update. Wait several minutes and do not unplug the AC cord. OK • If the software was not updated successfully, check the broadband connection and Internet Setting, and then try updating the software again. Failed to complete update. Please retry from Software Update menu. OK ■ Updating the Software with a USB Memory Device To check for the availability of a software update, visit http://www.sharpusa.com/products/support/. If you have any questions, please call 1-800-BE-SHARP (800-237-4277). CAUTION • Do not remove the USB memory device or unplug the AC cord while the software is being updated. • Be sure to properly follow the whole procedure described below, step by step. Otherwise, for example, the TV cannot read the data in the USB memory device and software updating will fail. 1 Insert the USB memory device with the update file into the USB 1 or USB 2 terminal on the TV. • When you update the software, use only one USB terminal. Either USB 1 or USB 2 is usable. 30% Abort Updating to latest firmware.. Version : XXXXXXXX 50% Remote Control operation is disabled during Update process. Do not unplug AC cord. CAUTION • Do not unplug the AC cord while the software is being updated. 2 Press c/d on the Manual Update screen to select "USB Memory", and then press ENTER. 35