Singer 14T968DC PROFESIONAL 5 Instruction Manual 31 - Page 28
needle clamp for Cover stitch and for Chain stitch.
View all Singer 14T968DC PROFESIONAL 5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Pass thread from back to the front through the thread guide 1. 1 Thread the top cover thread guide by pulling the thread towards the left until it slips under guide. 2 Then pull thread along the right side of button as illustrated. While holding thread with fingers, pass it between the tension discs and pull thread down to make certain it is properly located in between the tension discs 3. 3 2 3 Continue to thread points 4~8. Note: Slip thread into the middle slot of the thread guide 5 and into the slot of take-up lever cover 6. Then continue by slipping thread into the middle slot of the thread guides 7 and 8. Before threading eye of needle, make sure thread is in front of thread guide located on the bottom of the needle clamp for Cover stitch and for Chain stitch. 7 6 8 4 5 9 27