Sony BVMF250A User Manual (Operating Instructions - BVM-F250A / BVM-F170A) - Page 97

Chapter 4 Operations modes listed below. Set Right for the right signal, and Left for the left signal. Normal: Normal picture Black: Displays a black signal only (the video signal is not displayed). Mono: Displays the video signal in monochrome mode. Red: Displays only the red component of the video signal. Blue: Displays only the blue component of the video signal. Flip H display The input 3D video signals whose left (L) or right (R) signal has been inverted horizontally by a half-mirror type 3D rig are displayed as non-inverted images. Procedure 1 Input 3D video signals. 2 Set the desired display mode of the 3D signal analyzing function (Difference, Checkerboard, L/R Switch, Horopter Check or Flip H) to On by pressing the function button1) of the controller or in the Function Switch menu (page 67) of the Function Setting menu. If the desired display mode of the 3D signal analyzing function has been assigned to a pin of the PARALLEL REMOTE connector, set Parallel Remote (page 73) in the System Configuration menu to On. 1) Difference, Checkerboard, L/R Switch, Horopter Check or Flip H is assigned to a function button of the controller in the Function Key menu (page 83) of the Controller menu. To stop execution of the 3D signal analyzing function Set Difference, Checkerboard, L/R Switch, Horopter Check or Flip H to Off in the Function Switch menu (page 67) of the Function Setting menu. Or set the corresponding function button of the controller to off. The Difference, Checkerboard, L/R Switch or Horopter Check display is returned to the normal display and the currently selected left or right signal is displayed. The Flip H display is returned to the normal display without inversion. With serial number 7300001 or higher: - Difference - Four other display modes • To assign Checkerboard or L/R Switch to a function button of the controller, use the controller with software version 1.5 or higher. To assign Difference, Horopter Check or Flip H to a function button of the controller, use the controller with software version 1.6 or higher • If you change the channel when the 3D signal analyzing function is On, it is switched to Off. • If you display the Picture&Picture image when the 3D signal analyzing function is On, it is switched to Off. • If the input signal system is changed when the 3D signal analyzing function is On, the 3D video image may not be displayed correctly. • The 3D signal analyzing function cannot be set to On in the following cases: - When the option port number in which the BKM- 250TG is installed is not selected in Input Port of the Channel Configuration menu - When dual-link display is used - When the internal signal is displayed - When a captured frame is displayed - When Side by Side is set to On • The display of the 3D signal analyzing function may not be performed correctly when H Delay is set to On. • If saving is performed in HD Frame Capture when a 3D signal analyzing function other than Flip H is in use, the function is deactivated and the normal display is restored. Notes • To use the 3D signal analyzing function, use an optional BKM-250TG input adaptor. The available display modes of the 3D signal analyzing function differ depending on the serial number of the BKM-250TG as follows: With serial number 7100001 or higher: - Checkerboard - L/R Switch - Horopter Check - Flip H 97 Switching the Display of the 3D Video Signal