Sony DCRHC21 Operating Guide - Page 84
Using the Strap Belt as a wrist strap
UPC - 027242669819
View all Sony DCRHC21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
be affected as long as you are not recording the date. Procedures Connect your camcorder to a wall outlet using the supplied AC Adaptor, and leave it with the POWER switch set to OFF (CHG) for more than 24 hours. To change the battery of the Remote Commander While pressing on the tab, inset your fingernail into the slit to pull out the battery case. Place a new battery with the + side facing up. Insert the battery case back into the Remote Commander until it clicks. Tab Using the Strap Belt as a wrist strap This is useful for carrying your camcorder. 1 Open the hook and loop fastener of the hand pad () and remove it from the ring (). Hand pad 2 Move the hand pad fully to the right (), then close the hook and loop fastener again (). 2 WARNING Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire. Caution Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. • A button-type lithium battery (CR2025) is used in the Remote Commander. Do not use batteries other than the CR2025. • When the lithium battery becomes weak, the operating distance of the Remote Commander may shorten, or the Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion. 1 3 Use the Strap Belt as a wrist strap as illustrated. 84