Sony HT-NT5 Operating Instructions - Page 46
Sending the Remote Signal to the TV via the Unit, Using the Control for HDMI Function
View all Sony HT-NT5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Sending the Remote Signal to the TV via the Unit When the unit obstructs the remote control sensor of the TV, the TV remote control may not work. In that case, enable the IR repeater function of the system. You can control the TV with the remote control of the TV by sending the remote signal from the rear of the unit. 1 Press HOME. The home menu appears on the TV screen. 2 Select [Setup] from the home menu. The setup display appears on the TV screen. 3 Select [System Settings] - [IR- Repeater]. The [IR-Repeater] screen appears on the TV screen. 4 Select [On]. Notes • Be sure to check that the remote control of the TV cannot control the TV, and then set [IR-Repeater] to [On]. If it is set to [On] when the remote control can control the TV, appropriate operation may not be obtained because of the interference between the direct command from the remote control and the command via the unit. • On some TVs, this function may not work correctly. In this case, place the unit slightly further away from the TV. Using the Control for HDMI Function Connecting a device such as a TV or Bluray Disc recorder compatible with the Control for HDMI function* by HDMI cable enables you to easily operate the device by a TV remote control. The following functions can be used with the Control for HDMI function. • System Power Off function • System Audio Control function • Audio Return Channel • One-Touch Play function • Remote Easy Control • HDMI Standby Through power saving setting Note These functions may work with devices other than those manufactured by Sony, but operation is not guaranteed. * Control for HDMI is a standard used by CEC (Consumer Electronics Control) for allowing HDMI (High-Definition Multimedia Interface) devices to control each other. Preparing to Use the Control for HDMI Function Turn [System Settings] - [HDMI Settings] - [Control for HDMI] on the system to [On] (page 54). The default setting is [On]. Enable the Control for HDMI function settings for the TV and other device connected to the system. Tip If you enable the Control for HDMI ("BRAVIA" sync) function when using a TV manufactured by Sony, the Control for HDMI function of the system is also enabled automatically. When settings are 46US