Sony HT-NT5 Operating Instructions - Page 65
Remote Control, Others, PRTCT, PUSH and POWER - problems
View all Sony HT-NT5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Troubleshooting If there is an obstacle between the unit and the subwoofer, move or remove it. Locate the unit and the subwoofer as close as possible. Switch the wireless LAN frequency of any nearby Wi-Fi router or PC to 5 GHz range. Switch the network connection of the TV or Blu-ray Disc Player from wireless to wired. Remote Control The remote control of this system does not function. Point the remote control at the remote control sensor on the unit (page 8). Remove any obstacles in the path between the remote control and the system. Replace both batteries in the remote control with new ones, if they are weak. Make sure you are pressing the correct button on the remote control. TV remote control does not work. This problem might be solved by enabling the IR repeater function (page 54). Others The Control for HDMI function does not work properly. Check the connection with the system (refer to the supplied Startup Guide). Enable the Control for HDMI function on the TV. For details, refer to the operating instructions of your TV. Wait a while, and then try again. If you unplug the system, it will take a while before operations can be made. Wait for 15 seconds or longer, and then try again. Make sure the devices connected to the system support the Control for HDMI function. Enable the Control for HDMI function on the devices connected to the system. For details, refer to the operating instructions of your device. The type and number of devices that can be controlled by the Control for HDMI function is restricted by the HDMI CEC standard as follows: - Recording devices (Blu-ray Disc recorder, DVD recorder, etc.): up to 3 devices - Playback devices (Blu-ray Disc Player, DVD player, etc.): up to 3 devices - Tuner-related devices: up to 4 devices - Audio system (receiver/ headphone): up to 1 device (used by this system) "PRTCT," "PUSH" and "POWER" flash alternately in the front panel display. Press (power) to turn off the system. After the indicator disappears, disconnect the AC power cord (mains lead) and make sure nothing is obstructing the ventilation holes of the system. "BT TX" appears in the front panel display. Press RX/TX on the remote control to switch [Bluetooth Mode] to [Receiver]. "BT TX" appears if [Bluetooth Mode] is set to [Transmitter] (page 52). When you press RX/TX on the remote control, [Bluetooth Mode] is switched to [Receiver] and the selected input appears in the front panel display. 65US