Sony KF-50WE620 Operating Instructions (Large File - 11.3 MB) - Page 7

Antenna Grounding According to the NEC Refer to section 54-300 of Canadian Electrical Code for Antenna Grounding. Antenna lead-in wire Ground clamp Electrical service equipment NEC: National Electrical Code Antenna lead-in wire (NEC Section 810-20) Grounding conductors (NEC section 810-21) Ground clamps Power service grounding electrode system (NEC Art 250 Part H) Lightning For added protection for this television receiver during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the receiver due to lightning and power-line surges. Service Damage Requiring Service Do not attempt to service the set by yourself since opening the cabinet may expose you to dangerous voltage or other hazards. Unplug the set from the wall outlet and refer servicing to qualified service personnel under the following conditions: ❑ When the power cord or plug is damaged or frayed. ❑ If liquid has been spilled into the set. ❑ If the set has been exposed to rain or water. ❑ If the set has been subject to excessive shock by being dropped, or the cabinet has been damaged. ❑ If the set does not operate normally when following the operating instructions. Adjust only those controls that are specified in the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the set to normal operation. ❑ When the set exhibits a distinct change in performance, it indicates a need for service. Replacement Parts When replacement parts are required, be sure the service technician certifies in writing that he has used replacement parts specified by the manufacturer that have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock or other hazards. Safety Check Upon completion of any service or repairs to the set, ask the service technician to perform routine safety checks (as specified by the manufacturer) to determine that the set is in safe operating condition, and to so certify. When the set reaches the end of its useful life, ask a qualified service technician to dispose of the set. For Safety Be careful when moving the LCD projection TV When you place the LCD projection TV in position, be careful not to drop it on your foot or fingers. Watch your footing while installing the LCD projection TV. Carry the LCD projection TV in the specified manner If you carry the LCD projection TV in a manner other than the specified manner and without the specified number of persons, it may drop and a serious injury may be caused. Be sure to follow the instructions mentioned below. ❑ Carry the LCD projection TV with the specified number of persons (see page 22). ❑ Do not carry the LCD projection TV holding the speaker grill. ❑ Hold the LCD projection TV tightly when carrying it. ❑ Before carrying the LCD projection TV, disconnect any accessories or cables. 7