Sony KLV-32S400A Operating Instructions - Page 4
Checking the accessories, Inserting batteries into the remote, 1: Attaching the stand, Checking - klv s
View all Sony KLV-32S400A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Start-up Guide Checking the accessories AC power cord* (KLV-40S400A only) Stand (1) and screws (3) Remote RM-GA011 (1) Size AA batteries (R6 type) (2) * For models with ferrite cores, do not remove these cores. Inserting batteries into the remote Push and lift the cover to open. 1: Attaching the stand ~ • Observe the correct polarity when inserting batteries. • Do not use different types of batteries together or mix old and new batteries. • Dispose of batteries in an environmentally friendly way. Certain regions may regulate the disposal of batteries. Please consult your local authority. • Handle the remote with care. Do not drop or step on it, or spill liquid of any kind onto it. • Do not place the remote in a location near a heat source, a place subject to direct sunlight, or a damp room. 1 Place the TV onto the stand by aligning the screw hole alignment lines over the stand as shown. 2 Fix the TV to the stand according to the arrow marks that guide the screw holes using the supplied screws. ~ • This TV is very heavy, so two or more people should place the TV on the stand. • If using an electric screwdriver, set the tightening torque at approximately 1.5N·m (15kgf·cm). • When installing the TV onto the wall, follow step 1 to prevent the TV panel from falling over. • Ensure the AC power cord is away from screw holes during stand installation to avoid damage to the AC power cord (KLV-37S400A/KLV-32S400A/KLV26S400A only). 4 GB