Home » Sony Manuals » Remote Controls » Sony RM-VL700S » Manual Viewer

Sony RM-VL700S Operating Instructions - Page 20

Component Select buttons, flash again.

Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Programming signals of another remote control - Learning Function (continued) 3 Press and hold the button on the other remote control, until the SET indicator lights and all the Component Select buttons flash again. During data transfer, only the SET indicator stays lit, and the Component Select button turns off. If the SET indicator flashes five times It means that "learning" is incomplete. Repeat Steps 2 and 3. 4 Repeat Steps 2 and 3 to "teach" remote control signals to other buttons. 5 Press SET to finish "learning." Notes • If you do not perform Learning steps within 20 seconds at any point during the process, Learning mode ends. • If you do not perform Step 3 within 10 seconds after Step 2, the Learning procedure returns to Step 1. Repeat from Step 2 while the Component Select button lights. To cancel "learning," press SET. 20

Section	Page
Table of Contents	4
Getting Started	6
Installing the Batteries	6
When to replace the batteries	6
Location of Controls	7
Basic Operations	8
Setting the Code for non-Sony Preset Audio and Visual Components — Setting component codes	8
Setting a component code	8
Checking if the code number works	10
Setting a component code by the Search function	11
Operating Your Components with the Remote Commander	12
To control the volume	13
Notes on operating your components	14
Programming signals of another remote control — Learning Function	15
For accurate Learning	18
Programming remote control signals to the Component Select buttons	19
Changing or erasing the function of a “learned” button	21
Notes on programming the signals for an air-conditioner	23
Advanced Features	24
Controlling the Volume of Visual Components Connected to an Audio System	24
Adding an Extra Function to the Component Select Buttons	26
Programming the Power-On Command of the Selected Component just by pressing that Component Select button (for Sony Components	26
Assigning Other Components to the Component Select Buttons	27
Copying the settings of a Component Select button to another button	29
Using Other Functions	30
Locking the Controls — Hold Function	30
Erasing all settings — To reset the Commander to its factory settings	31
Additional Information	32
Precautions	32
Specifications	32
Troubleshooting	33
Appendix	35
Table of Preset Functions	35
TV	35
VCR	36
CBL (Cable box)	36
SAT	37
DVD	37
CD	38
MD	38
DAT	38
DECK	38
AMP	39
Digital Cable Box	39