Sony RM-VL700S Operating Instructions - Page 26

Adding an Extra Function to the Component Select Buttons Programming the Power-On Command of the Selected Component just by pressing that Component Select button (for Sony Components only) When using Sony components, you can program the Power-On signal for each component on a Component Select button. You can select the desired component and power it on by just pressing that Component Select button. 2 While holding POWER pressed, press the desired Component Select button. When you first press POWER, only the Component Select buttons that have already been set with the Power-On command light up. Example: If the Power-On command has been programmed on the VCR and DVD buttons, these buttons light up when you first press POWER. Example: To program the TV button 1 Press SET. All Component Select buttons flash. To cancel setting, press SET. To clear the Power-On command Repeat the same procedure, pressing the desired Component Select button that lights up when you press POWER. Notes • If the component code of a non-Sony brand has been set on a Component Select button, you cannot program the Power-On function on it. If you change the component code (page 8) after setting the Power-On function, the Power-On function is cleared. • Even if you used the Learning function (page 15) to program a signal on a Component Select button, you can program the Power-On function on that button but it cannot be used. If you clear the "learned" function on that button, you can use the Power-On function. 26