Home » Sony Manuals » Audio Components » Sony STR-DA5300ES » Manual Viewer

Sony STR-DA5300ES Operating Instructions (Large File - 21.32 MB) - Page 139

Troubleshooting, On operation, On cleaning, Audio

Add to My Manuals
Save this manual to your list of manuals

Page 139 highlights

• Do not place the receiver near heat sources, or in a place subject to direct sunlight, excessive dust, or mechanical shock. • Do not place anything on top of the cabinet that might block the ventilation holes and cause malfunctions. • Do not place the receiver near equipment such as a television, VCR, or tape deck. (If the receiver is being used in combination with a television, VCR, or tape deck, and is placed too close to that equipment, noise may result, and picture quality may suffer. This is especially likely when using an indoor antenna (aerial). Therefore, we recommend using an outdoor antenna (aerial).) On operation Before connecting other components, be sure to turn off and unplug the receiver. On cleaning Clean the cabinet, panel, and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine. If you have any questions or problems concerning your receiver, please consult your nearest Sony dealer. Troubleshooting If you experience any of the following difficulties while using the receiver, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. Audio There is no sound, no matter which component is selected, or only a very low-level sound is heard. • Check that the speakers and components are connected securely. • Check that all speaker cords are connected correctly. • Check that both the receiver and all components are turned on. • Check that MASTER VOLUME control is not set at -∞ dB. Try to set it at about -40 dB. • Check that SPEAKERS (OFF/A/B/A+B) is not set to OFF (page 46). • Press MUTING on the remote to cancel the muting function. • Check that you have selected the correct component with INPUT SELECTOR. • Check that headphones are not connected. • When only a very low-level sound is heard, check to see if NIGHT MODE is activated (page 73). • The protective device on the receiver has been activated. Turn off the receiver, eliminate the short-circuit problem, and turn on the power again. There is no sound from a specific component. • Check that the component is connected correctly to the audio input jacks for that component. • Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the receiver and the component. continued 139GB Additional Information

Section	Page
GB	2
Table of Contents	4
Getting Started	6
Description and location of parts	6
1: Installing speakers	16
2: Connecting speakers	18
3: Connecting the monitor	20
4a: Connecting the audio components	22
4b: Connecting the video components	27
5: Connecting the antennas (aerials)	38
6: Preparing the receiver and the remote	39
7: Operating the receiver using the GUI (Graphical User Interface)	41
8: Setting the speakers	44
9: Calibrating the appropriate speaker settings automatically (Auto Calibration)	46
Playback	53
Selecting a component	53
Listening to a Super Audio CD/CD	55
Watching a DVD/Blu-ray Disc	56
Enjoying video games	57
Watching video	58
Amplifier Operations	59
Settings for the audio (Audio settings menu)	59
Settings for the video (Video settings menu)	60
Settings for HDMI (HDMI menu)	60
Settings for the system (System settings menu)	61
Enjoying Surround Sound	62
Enjoying a pre- programmed sound field	62
Adjusting the sound effect	69
Using the surround back decoding mode	71
Enjoying the surround effect at low volume levels (NIGHT MODE)	73
Advanced Speakers Setting Up	74
Adjusting the speaker settings manually	74
Adjusting the equalizer	80
Tuner Operations	82
Listening to FM/AM radio	82
Listening to satellite radio	85
Other Operations	94
Converting analog video input signals	94
Using the DIGITAL MEDIA PORT adapter	94
Naming inputs	98
Switching between digital and analog audio (INPUT MODE)	99
Enjoying the sound/ images from other inputs	100
Changing the display	102
Using the sleep timer	106
Recording using the receiver	107
Listening to the sound in another zone (ZONE 2/ZONE 3 operations)	108
Using a bi-amplifier connection	113
Using the CONTROL S Control System	114
Operating without connecting to the TV	115
Using the Remote	125
Operating each component using the remote	125
Programming the remote	127
Performing several commands in sequence automatically (Macro Play)	130
Setting remote control codes that are not stored in the remote	132
Clearing all the contents of the remote’s memory	134
Additional Information	135
Glossary	135
Precautions	138
Troubleshooting	139
Specifications	143
Index	146
FR	150
Table des matières	152
Mise en service	154
Description et emplacement des pièces	154
1: Installation des enceintes	165
2: Raccordement des enceintes	167
3: Raccordement de l’écran	169
4a: Raccordement des appareils audio	171
4b: Raccordement des appareils vidéo	177
5: Raccordement des antennes	188
6: Préparation de l’ampli- tuner et de la télécommande	189
7: Utilisation de l’ampli- tuner à l’aide de GUI (Graphical User Interface)	192
8: Réglage des enceintes	195
9: Calibrage automatique aux réglages appropriés (Auto Calibration)	197
Lecture	204
Sélection d’un appareil	204
Écoute d’un Super Audio CD/CD	206
Lecture d’un DVD/Blu-ray Disc	207
Utilisation d’une console de jeux vidéo	208
Lecture d’une cassette vidéo	209
Opérations de l’amplificateur	210
Paramètres pour l’audio (Menu de paramétrage Audio)	210
Paramètres pour la vidéo (Menu de paramétrage Video)	211
Paramètres pour HDMI (Menu HDMI)	211
Paramètres pour le système (Menu de paramétrage System)	212
Écoute du son surround	213
Écoute d’un champ sonore préprogrammé	213
Sélection de l’effet sonore	221
Utilisation du mode de décodage du son surround arrière	223
Écoute du son surround à faible volume (NIGHT MODE)	225
Paramétrage avancé des enceintes	227
Réglage manuel des paramètres d’enceintes	227
Réglages de l’égaliseur	234
Opérations du tuner	236
Écoute de stations de radio FM/AM	236
Écoute de la radio satellite	240
Autres opérations	251
Conversion de signaux d’entrée vidéo analogiques	251
Utilisation de l’adaptateur DIGITAL MEDIA PORT	252
Attribution de noms à des entrées	256
Passage entre son numérique et analogique (INPUT MODE)	257
Écoute du son/visionnage d’images d’autres entrées	258
Changement des informations sur l’affichage	261
Utilisation de la minuterie d’arrêt	266
Enregistrement à l’aide de l’ampli-tuner	267
Écoute du son dans une autre zone (opération ZONE 2/ ZONE 3)	268
Utilisation d’un raccordement bi- amplificateur	273
Utilisation du système de commande CONTROL S	274
Utilisation sans raccordement au téléviseur	275
Utilisation de la télécommande	286
Commande de chaque appareil à l’aide de la télécommande	286
Programmation de la télécommande	288
Exécution automatique d’une séquence de plusieurs commandes (Exécution de macro-commandes)	291
Mémorisation de codes de télécommande n’ayant pas été préprogrammés dans la télécommande	293
Effacement de tout le contenu de la mémoire de la télécommande	295
Informations complémentaires	296
Glossaire	296
Précautions	299
Guide de dépannage	300
Spécifications	305

Match case Limit results 1 per page

139

Additional Information

•

Do not place the receiver near heat sources,

or in a place subject to direct sunlight,

excessive dust, or mechanical shock.

•

Do not place anything on top of the cabinet

that might block the ventilation holes and

cause malfunctions.

•

Do not place the receiver near equipment

such as a television, VCR, or tape deck. (If

the receiver is being used in combination

with a television, VCR, or tape deck, and is

placed too close to that equipment, noise

may result, and picture quality may suffer.

This is especially likely when using an

indoor antenna (aerial). Therefore, we

recommend using an outdoor antenna

(aerial).)

On operation

Before connecting other components, be sure

to turn off and unplug the receiver.

On cleaning

Clean the cabinet, panel, and controls with a

soft cloth slightly moistened with a mild

detergent solution. Do not use any type of

abrasive pad, scouring powder, or solvent,

such as alcohol or benzine.

If you have any questions or problems

concerning your receiver, please consult your

nearest Sony dealer.

Troubleshooting

If you experience any of the following

difficulties while using the receiver, use this

troubleshooting guide to help you remedy the

problem. Should any problem persist, consult

your nearest Sony dealer.

Audio

There is no sound, no matter which

component is selected, or only a very

low-level sound is heard.

• Check that the speakers and components

are connected securely.

•

Check that all speaker cords are connected

correctly.

• Check that both the receiver and all

components are turned on.

•

Check that MASTER VOLUME control is

not set at –

∞

dB. Try to set it at about –40

dB.

• Check that SPEAKERS (OFF/A/B/A+B)

is not set to OFF (page 46).

• Press MUTING on the remote to cancel

the muting function.

• Check that you have selected the correct

component with INPUT SELECTOR.

• Check that headphones are not connected.

• When only a very low-level sound is

heard, check to see if NIGHT MODE is

activated (page 73).

• The protective device on the receiver has

been activated. Turn off the receiver,

eliminate the short-circuit problem, and

turn on the power again.

There is no sound from a specific

component.

• Check that the component is connected

correctly to the audio input jacks for that

component.

• Check that the cord(s) used for the

connection is (are) fully inserted into the

jacks on both the receiver and the

component.

continued