Sony STR-DH520 Operating Instructions - Page 38

1 Press the corresponding input button which you want to check the information. 2 Press AMP MENU, then press DISPLAY repeatedly. Each time you press the button, the display changes cyclically as follows: Index name of the input* t Selected input t Sound field currently applied t Volume level t Stream info** When listening to FM and AM radio Preset station name* t Frequency t Sound field currently applied t Volume level When receiving RDS broadcasts (Europe, Australia and Taiwan models only) Program Service name or preset station name* t Frequency, band and preset number t Sound field currently applied t Volume level * Index name appears only when you have assigned one to the input or preset station (page 37, 42). Index name does not appear when only blank spaces have been entered, or it is the same as the input name. **Stream information may not be displayed. Note Character or marks may not be displayed for some languages. Recording using the receiver You can record from an audio/video equipment using the receiver. Refer to the operating instructions supplied with your recording equipment. 1 Press the input button which corresponds to the playback equipment. You can also use INPUT SELECTOR on the receiver. 2 Prepare the playback equipment for playing. For example, insert the video tape you want to copy into the VCR. 3 Prepare the recording equipment. Insert a blank video tape, etc. into the recording equipment (VIDEO) for recording. 4 Start recording on the recording equipment, then start the playback equipment. Notes • Some sources contain copyright protection to prevent recording. In this case, you may not be able to record from the source. • Only analog signals are output from the analog output jack (for recording). • HDMI sound cannot be recorded. • While only composite video signals are being recorded, the auto standby function of the receiver may start up and interrupt the recording. In this case, set the "AUTO.STBY" to "STBY OFF" (page 60). 38GB