Sony STR-DH520 Operating Instructions - Page 40
If you cannot tune to a station, Tuning to a station directly, Direct Tuning - reset
UPC - 027242809369
View all Sony STR-DH520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Tuning to a station directly (Direct Tuning) You can enter the frequency of a station directly by using the numeric buttons. 1 Press TUNER repeatedly to select the FM or AM band. You can also use INPUT SELECTOR on the receiver. 2 Press D.TUNING. 3 Hold down SHIFT, then press the numeric buttons to enter the frequency. Example 1: FM 102.50 MHz • USA and Canada models only: Select 1 b 0 b 2 b 5 • Other models: Select 1 b 0 b 2 b 5 b 0 Example 2: AM 1,350 kHz Select 1 b 3 b 5 b 0 Tip Adjust the direction of the AM loop antenna (aerial) for optimum reception upon tuning to an AM station. 4 Press . If you cannot tune to a station Make sure you have entered the right frequency. Try repeating steps 2 to 4. If you still cannot tune to a station, the frequency may not be in use in your area. Changing the AM tuning scale (USA and Canada models only) You can change the AM tuning scale to either 9 kHz or 10 kHz using the buttons on the receiver. ?/1 TUNING MODE 1 Press ?/1 to turn off the receiver. 2 While holding down TUNING MODE, press ?/1. 3 Change the current AM tuning scale to 9 kHz (or 10 kHz). To reset the scale to 10 kHz (or 9 kHz), repeat the procedure above. Note All preset stations will be erased when you change the tuning scale. 40GB