TP-Link T1500-28PCT T1500-28PCTTL-SL2428PUN V3 CLI Reference Guide Guide - Page 251

26.2 storm-control Description The storm-control command is used to enable the broadcast, multicast, or unknown unicast strom control function and to set threshold levels on an interface. To return to the default configuration, please use no storm-control command. Syntax storm-control { broadcast | multicast | unicast } { rate } no storm-control { broadcast | multicast | unicast } Parameter broadcast | multicast | unicast -- Select the mode of the storm control on the interface. rate -- Specify the bandwidth for receiving packets on the port. The specified type of packet traffic exceeding the bandwidth will be processed according to the configuration of storm-control exceed command. For kbps, the rate ranges from 1 to 1000000 kbps (for the gigaport), or 1 to 100000 kbps (for the fastport). For ratio, the rate ranges from 1 to 100 percent. Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet /interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Configure the broadcast storm control rate as 1024 kbps on port 1/0/5: Switch(config)# interface gigabitEthernet 1/0/5 Switch(config-if)# storm-control rate-mode kbps Switch(config-if)# storm-control broadcast 1024 232