Uniden BCD325P2 Owners Manual - Page 36
Set Backlight
View all Uniden BCD325P2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
When you select 'AUTO' for a channel or mode's modulation or step, the above values are used unless you've edited the Band Defaults. Although TV bands are listed, the scanner cannot decode digital TV audio. SETTINGS MENUS To Edit Settings press Menu. Scroll to 'Settings' and press E/yes. Scroll to the settings and options below (in Blue) and press E/yes. Set Backlight Adjust Key Beep Battery Option Adjust Contrast Set C-CH Output Set GPS Format Set GPS Baud Rate Band Default P25 LP Filter Disp. Unit ID See Scanner Info Locking/Unlocking the Keypad Viewing Battery level Cloning Scanner Reset Set Backlight To use the backlight press 3 light intensities. . There are 5 different ways to use the backlight and 1. Scroll to 'Set Backlight' and press E/yes. 2. At 'Set Mode' press E/yes. 3. Scroll to 1 of 5 settings and press E/yes to save and exit. 10 sec - The backlight stays on for 10 seconds after you press . 30 sec - The backlight stays on for 30 seconds after you press . Squelch - The backlight turns on when the squelch opens then stays on for 5 seconds. Keypress - The backlight turns on when any key is pressed then stays on for 10 seconds. Infinite - The backlight turns on when you press then stays on until you press again. 4. Scroll to 'Set Dimmer' and press E/yes. Scroll to 'High', 'Middle', 'Low' or 'Off' and press E/yes to save and exit. 5. Press Menu to return. 36