Vtech InnoTab 3 Plus - The Learning Tablet User Manual - Page 8

Getting started Charging and Recharging the Batteries The rechargeable batteries should be fully charged before the first use. To charge and recharge the batteries, please follow the instructions below. 1. Make sure the battery packs are installed in the tablet. 2. Use the AC adapter that comes with the InnoTab® 3. Plug one end of the AC adapter into the power jack on the InnoTab® 3 and plug the other end into a wall outlet. Note: The AC adapter is not a toy, and should only be used by an adult. 3. You can continue to use the InnoTab® 3 while the AC adapter is connected, but the batteries will not charge while the InnoTab® 3 is on. When you're done playing, turn the power off and leave the tablet connected to a wall outlet to charge it. 4. The green light on the tablet will flash to indicate charging is in progress. When the batteries are fully charged the light will turn off. A full charge takes about 4.5 hours with the AC adapter. Note: If the green light on the tablet flashes very quickly during charging, the battery packs may not be connected properly. Please reinstall the battery packs and try again. Important Notes: • Make sure the InnoTab® 3 is turned off before charging. • The tablet will charge at temperarures between 5°C~35°C (41°F~95°F). If the tablet is not charging properly, please move it to a location with a suitable temperature. • Battery removal and replacement should only be done by an adult. • Keep the connector pins on the InnoTab® 3 and the metal contacts on the battery packs clean for optimal performance. • Disconnect the tablet from the AC adapter and remove the battery packs before cleaning. • For best results, please use the AC adapter that's included in this package. Warning: Do not allow any metal objects to touch the metal contacts on the battery packs or the contact pins on the InnoTab® 3. 5