Vtech VH6212 User Manual - Page 36
I have manually, or accidentally, deregistered, my headset, from the, Dongle., ON/OFF
View all Vtech VH6212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Appendix Troubleshooting I have manually or accidentally deregistered my headset from the Dongle. The VH6212 headset comes pre-registered to the Dongle. If, for some reason, the headset is not registered to the Dongle, follow the instructions below to register your headset to the Dongle. 1. Make sure the battery is properly installed in the headset. The headset LED light flashes slowly in red and blue to indicate the headset is not registered. 2. Place the headset in the charger cradle and allow it to charge for at least one hour before beginning registration. 3. Remove the headset from the charger cradle. 4. Press and hold the pair button on the Dongle for about four seconds until the Dongle LED light on flashes red very quickly, and then release the button. 5. Return the headset to the charger cradle for registration. The headset LED light alternates quickly in red and blue. It takes about 60 seconds to complete the registration process. Once the headset is registered, the headset LED light turns red when the battery is low and being charged, or turns purple when the battery is well charged, or turns blue when the battery is fully charged. If the registration fails, you hear the voice prompt "Not registered" when you press the headset ON/OFF button on the headset, and the headset ON/OFF button light on the headset alternates slowly in red and blue. 31