Weider 7400 Weight English Manual - Page 19
Trouble, Shooting, Maintenance
View all Weider 7400 Weight manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
TROUBLE-SHOOTING AND MAINTENANCE Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. Locate the adjustment sleeve and adjustment screw near the lower end of the Short Cable (23). Loosen the adjustment screw. Pull the end of the Short Cable until there is no slack. Slide the adjustment sleeve and the ball against the indicated 3 1/2" Pulley (15). Retighten the adjustment screw. Make sure that the cables are not too tight, or the top weight will be lifted off the weight stack. 15 Adjustment Screw 23 Ball 15 Adjustment Sleeve If the cables need to be replaced, see ORDERING 23 REPLACEMENT PARTS on the back cover of this owner's manual. 19