Weider Pro 450 English Manual - Page 6

ASSEMBLY Make Things Easier for Yourself This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two people. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. The following tools (not included) are required for assembly: • Two adjustable wrenches • One rubber mallet • One standard screwdriver • One Phillips screwdriver • Lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before assembling this product, make sure you understand the information in the box above. 1 Identify the Right Upright (1) by the position of the adjustment brackets. Press a 51mm x 76mm Square Inner Cap (24) into the top of the Right Upright. Press a 2" Square Inner Cap (17) into each end of the Right Stabilizer (26). Insert four M10 x 62mm Carriage Bolts (33) up through the Right Stabilizer (26). (Note: On one side of the Stabilizer there is an indentation around each hole. Insert the Bolts from this side.) Place the Right Stabilizer flat on the floor. Slide the Right Upright (1) onto the four M10 x 62mm Carriage Bolts (33) in the Right Stabilizer (26). Attach the Upright with four M10 Nylon Locknuts (11). Set the Right Upright (1) aside, making sure that it cannot fall. 24 1 Adjustment Brackets 11 11 17 26 17 33 33 6