Weider Pro 9300 English Manual - Page 12

20. Wrap the Butterfly Cable (88) around a 3 1/2" 20 Pulley (82) as shown. Attach the Pulley and a Cable Trap (80) to the bracket on the Press Upright (4) with a 3/8" x 2" Bolt (50) and a 3/8" Nylon Locknut (42). The Cable Trap must be oriented as shown and be posi- tioned to hold the Cable in the groove of the Pulley. 82 50 80 42 4 88 21. Locate one of the preassembled pairs of 21 Pulley Plates (31) and 3 1/2" Pulleys (82). Route the Butterfly Cable (88) under the indicated 3 1/2" Pulley (82). The end of the Pulley Plates (31) with two holes should be downward. Be sure that the Cable is between the Cable Trap (80) and the Pulley, and that the Cable Trap is positioned to hold the Cable in place. Refer to the inset drawing. Tighten the 3/8" x 2" Bolt (50) and the 3/8" Nylon Locknut (not shown). 88 88 82 50 80 End with two holes 31 should be down 22. Wrap the Butterfly Cable (88) around a 3 1/2" Pulley (82) as shown. Attach the Pulley and a 22 Cable Trap (80) to the other side of the bracket on the Press Upright (4) with a 3/8" x 2" Bolt (50) and a 3/8" Nylon Locknut (42). The Cable Trap must be oriented as shown and be positioned to hold the Cable in the groove of the Pulley. 80 50 42 82 88 4 CABLE ASSEMBLY 23. Note: The Left Fly Arm (6) is shown removed for easier part identification. 23 Attach the Butterfly Cable (88) to the the bracket on the Left Fly Arm (6) with a 5/16" x 1" Shoulder Bolt (51) and a 5/16" Nylon Nylon Locknut (40). 51 88 40 6 12