Weider Pro 9300 English Manual - Page 6

1. Before you begin this step, make sure that you have read all of the information on page 5. This brief introduction will save you much more time than it takes to read it! Locate and open the parts bags labeled "FRAME ASSEMBLY BAG ONE" and "FRAME ASSEMBLY BAG TWO." Press two 2" Square Outer Caps (58) onto the Weight Base (14) in the indicated locations. Press a 2" Square Inner Cap (56) into the end of the Weight Base. Insert two 5/16" x 2 1/2" Carriage Bolts (49) up through the Weight Base (14). Insert four 5/16" x 2 1/2" Carriage Bolts up through the Press Base (13). Press a 2" Square Inner Cap (56) into the end of the Press Base (13). Attach the Press Base to the Weight Base (14) with two 5/16" x 2 3/4" Bolts (55), two 5/16" Washers (20), and two 5/16" Nylon Locknuts (40). 2. Slide the Ab Upright (1) onto the indicated 5/16" x 2 1/2" Carriage Bolts (49) in the Weight Base (14). Hand tighten two 5/16" Nylon Locknuts (40) onto the Carriage Bolts. Do not tighten the Nylon Locknuts yet. Slide the Press Upright (4) onto the indicated 5/16" x 2 1/2" Carriage Bolts (49) in the Press Base (13). Hand tighten two 5/16" Nylon Locknuts (40) onto the Carriage Bolts. Do not tighten the Nylon Locknuts yet. 1 58 55 58 14 20 49 56 2 13 40 49 56 1 4 40 40 FRAME ASSEMBLY 3. Press two 2" Square Inner Caps (56) into the ends of the Top Frame (2). Press two 2" Square Inner Caps (56) into the indicated sides of the Butterfly Frame (3). Press two 1" Inner Caps (65) into the top of the Butterfly Frame. Attach the Butterfly Frame (3) to the Top Frame (2) with a 5/16" x 3" Bolt (91), 5/16" Washers (20), and a 5/16" Nylon Jam Nut (90). Be sure that the Bolt is on the side shown. Finish attaching the Butterfly Frame (3) to the Top Frame (2) with a 5/16" x 2 3/4" Bolt (55), 5/16" Washers (20), and a 5/16" Nylon Locknut (40). 6 3 2 56 14 13 49 49 90 20 40 20 56 91 65 56 55 3 56