Weider Pro 9300 English Manual - Page 13
Attach the Rear Cable 86 to a Small U
View all Weider Pro 9300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
24. Identify the Rear Cable (86)-this is the 24 shortest Cable. Slide one end of the Rear Cable onto the 5/16" x 3" Bolt (91) on the Top Frame (2). Thread a 5/16" Nylon Jam Nut (90) onto the Bolt. Do not fully tighten the Jam Nut; leave enough room between the two Jam Nuts for the Cable to pivot. 2 90 91 86 CABLE ASSEMBLY 25. See the inset drawing. Attach a 3 1/2" Pulley (82) and a Cable Trap (80) to the upper hole in the Large "U" Bracket (83) with a 3/8" x 2" Bolt (50) and a 3/8" Nylon Locknut (42). Be sure that the Cable Trap is inside the Large "U" Bracket. Note: This may come pre-assembled. 25 86 Route the Rear Cable (86) through the Large "U" Bracket (83) and the 3 1/2" Pulley (82). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly. 82 80 42 50 83 86 82 83 26. Wrap the Rear Cable (86) around a 3 1/2" 26 Pulley (82). Attach the Pulley to the Top Frame (2) with a 3/8" x 2" Bolt (50) and a 3/8" Nylon Locknut (42). The Cable must be routed in the direction shown. 2 42 50 82 86 27. Attach the Rear Cable (86) to a Small "U" 27 Bracket (32) with a 1/4" Washer (37) and a 1/4" Nylon Locknut (44). Do not completely 32 tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a 68 couple of turns, as shown in the inset drawing. Attach the Small "U" Bracket (32) to the indicated Weight Tube (25) with a 5/16" x 1 3/4" 32 86 Bolt (68) and a 5/16" Nylon Locknut (40). 37 44 13 86 40 37 44 25